ResMed 2011-09, 248551/1 manual Tailoring treatment setup options, Using mask-fit

Page 19

Tailoring treatment setup options

Setting Ramp

Ramp time

Ramp time is a feature that can be enabled by your clinician by setting a maximum ramp time. Designed to make the beginning of treatment more comfortable, ramp time is the period during which the pressure increases from a low start pressure to the treatment pressure. See “Setup menu: Options” on page 16.

Programs

Program		If the Clinician has selected both, ie, dual,
		you can choose the program to use on the
		you can choose the program to use on the
		Treatment screen. If only a single program is
		selected, the option does not display.

Using mask-fit

You can use mask-fit to help you fit your mask properly. This feature delivers constant treatment pressure for a three-minute period, prior to starting treatment, during which you can check and adjust your mask-fit to minimise leaks. The mask-fit pressure is the set CPAP or EPAP pressure or 10 cm H2O, whichever is greater.

1Put the mask on according to the mask user guide.

2Hold down for at least three seconds until pressure delivery starts.

3If necessary adjust the mask, mask cushion and headgear until you have a good mask fit. After three minutes treatment will begin. Mask-fit can be stopped at any time by pressing .

Notes:

•Press for at least three seconds during mask-fit to start the treatment immediately.

•The mask-fitting feature is disabled when the mask type Trach is selected.

14

Image 19

Contents User Guide StellarRespiratory Care Solutions Making quality of care easy Stellar 100 Stellar Contents Cleaning and maintenance Adverse effects IntroductionIndications for use ContraindicationsStellar at a glance ResMed USB stick Internal batteryPatient interface HumidificationMobile use Setting up for noninvasive useAttaching the H4i heated humidifier for noninvasive use Setting up for invasive useHmef Attaching the pulse oximeter Working with other optional accessoriesAdding supplemental oxygen Stopping therapy using oxygen Starting therapy using oxygenUsing the FiO2 monitoring sensor Attaching an antibacterial filter Connecting a sensorAbout the control panel Stellar basicsLCD screen Starting therapyPerforming a functional test Check pulse oximeter if in use Starting therapyStopping therapy Check the FiO2 monitoring sensor if in useWorking with alarms Turning off the powerUsing mask-fit Tailoring treatment setup optionsUsing the menus Enu Options Enu Alarm Settings Alarm VolumeParameter Description Setup menu Configuration MenuOptions On, Auto Device Information Info menuEvent Summary Used HoursData management Cleaning and maintenanceDaily Disinfection WeeklyMonthly Replacing the air filterServicing TroubleshootingAlarm troubleshooting Multipatient useLCD Over Pressure Problem / possible cause Action LCD Internal Battery EmptyLCD High Temperature 10, 11, 12 LCD System FailureLCD Low Respiratory Rate!, High Respiratory Rate Problem / possible cause Action LCD Circuit disconnectedLCD Internal Battery Low LCD Low Minute VentilationOther troubleshooting Treatment pressure seems high Problem / possible cause SolutionDevice does not start when you breathe into the mask Device does not stop when you remove your maskTechnical specifications Power supply Alarm Volume RangeDimensions L x W x H Weight Air outletClassifications IECAir travel requirements Vrms General warnings and cautions SymbolsGeneral warnings and cautions Product Warranty period Limited warrantyApac