ResMed 248551/1, 2011-09 manual Using the menus

Page 20

Using the menus

The device has three menus (Monitoring, Setup, Info) accessed by the equivalent buttons on the right of the LCD screen. In each menu there are screens that display settings, device or therapy information.

MONITORING	SETUP	INFO
Treatment	Clinical Settings	Event Summary

English

Monitoring

Pressure / Flow

Alarm Settings

Min Vent/Resp Rate

or MV/Va (iVAPS

Mode)

Options

Leak

Tidal Volume

Synchronisation

Oximetry

Leak

Minute Ventilation

Tidal Volume

Respiratory Rate

I:E Ratio

Pressure Support

AHI

SpO2

Used Hours

Device Information

Reminder

Note: iVAPS mode is only available in Stellar 150.

Using the menus

Image 20

Contents Stellar User GuideRespiratory Care Solutions Making quality of care easy Stellar 100 Stellar Contents Cleaning and maintenance Introduction Indications for useContraindications Adverse effectsStellar at a glance Internal battery Patient interfaceHumidification ResMed USB stickSetting up for noninvasive use Mobile useSetting up for invasive use Attaching the H4i heated humidifier for noninvasive useHmef Adding supplemental oxygen Working with other optional accessoriesAttaching the pulse oximeter Using the FiO2 monitoring sensor Starting therapy using oxygenStopping therapy using oxygen Connecting a sensor Attaching an antibacterial filterStellar basics About the control panelPerforming a functional test Starting therapyLCD screen Starting therapy Stopping therapyCheck the FiO2 monitoring sensor if in use Check pulse oximeter if in useTurning off the power Working with alarmsTailoring treatment setup options Using mask-fitUsing the menus Enu Alarm Settings Alarm Volume Enu OptionsOptions On, Auto Setup menu Configuration MenuParameter Description Info menu Event SummaryUsed Hours Device InformationDaily Cleaning and maintenanceData management Weekly MonthlyReplacing the air filter DisinfectionTroubleshooting Alarm troubleshootingMultipatient use ServicingProblem / possible cause Action LCD Internal Battery Empty LCD High Temperature 10, 11, 12LCD System Failure LCD Over PressureProblem / possible cause Action LCD Circuit disconnected LCD Internal Battery LowLCD Low Minute Ventilation LCD Low Respiratory Rate!, High Respiratory RateOther troubleshooting Problem / possible cause Solution Device does not start when you breathe into the maskDevice does not stop when you remove your mask Treatment pressure seems highTechnical specifications Alarm Volume Range Dimensions L x W x HWeight Air outlet Power supplyAir travel requirements IECClassifications Vrms Symbols General warnings and cautionsGeneral warnings and cautions Limited warranty Product Warranty periodApac