Vermont Casting DVBR42, DVBR36 manual Installation of Logs Ember Material Placement, Lava Rock

DVBR Series Direct Vent Gas Fireplace
Installation of Logs				Ember Material Placement
	Log Chart			Separate the ember material into small pieces, roughly
Logs	DVBR36	DVBR42		1/2” in diameter and place onto the burner in front of
				the front logs. Do NOT pack down, leave in fluffy, loose
Left Log	20008817	20008508
				condition for most realistic ember effect.
Right Log	20008819	20008510
				Lava Rock
Right Rear Log	20008818	20008509
Left Cross Log	20008820	20008515
Log Top Right	--		B29	The lava rock provided with this fireplace must be placed
Right Cover Log	20008822	20008515		on the firebox base around the burner assembly.
Left Rear Log	20008513	20008816
Center Log	20008821	20008514		Under no circumstances should this lava
Left Front Log	20008823	20008823		rock be placed on any part of the burner
Left Cover Log	20008512	20008512		assembly.
1 . Remove front glass. (See “Glass Remov-				Right Rear Log
al” Section, Fig. 48)
2. Remove logs from packaging.			Left Rear
As with all plastics — these are
			Log
not toys and should be kept
away from children and infants.

3. Place Right Rear Log onto the two pem studs on the rear log support. Place the Left Rear Log on the left side of the rear log support and push the log up against the Right Rear Log. (Fig. 50)

4. Place the Left Log on the pem studs on the left side of the burner. Place the Right Log on the pem studs on the right side of the burner. (Fig. 51)

5. Place the front edge of the Left Cover
Log on the front top edge of the burner
between the last two left tines of the		LG340
grate. Allow the bottom edge of the log to	Fig. 50	Place Right and Left Rear Logs on rear log support.
sit on the hearth. Place the Right Cover
Log between the right two tines and rest		Right Log
the log up against the front face of the
burner. (Fig. 52)

6. Place the Center Log between the sec- ond and third tines as shown. Place the v-notch on the left side of the Center Log against the left tine of the grate. Rest the right side of the Center log up against the face of the Right Log. (fig. 52)

7. Place the left Cross Log over the pin of the Right Rear Log and the pin of the Left Log. (Fig. 3)

8. DVBR42 only. Place the Right Cross Log
over the Right Rear Log and the Right
Log as shown. (Fig. 53) When positioned	Left Log
correctly, the right rear flame will come up	LG390
through the hole in the Right Cross log.	Fig. 51 Place Left and Right Logs on pem studs on burner.
Carefully adjust the log as needed to al-

low the flame to come through the hole.

24 20000584