Vermont Casting DVBR36, DVBR42 Optional Accessories, Optional Fk-12 Fan Hook-up, Remote Controls

DVBR Series Direct Vent Gas Fireplace

Optional Accessories

Optional Fk-12 Fan Hook-up

1.Remove control cover from unit.

2.Remove glass door by rotating latches at bottom corners of door. Refer to Page 23.

3.Remove the 9 screws securing burner to combustion bottom.

4.Remove burner by lifting up and rotating toward front of unit.

5.Set burner aside.

6.Install FK-12 fan in back of unit between hearth sup- ports. (Fig. 72)

7.Secure fan on velcro strips.

8.Plug fan into EB-1 receptacle.

9.Be sure fan motor does not touch hearth supports.

Any electrical re-wiring of this fan must be completed by a qualified electrician.

Turn off all power before hook-up.

	Cold Air Box			Top View
Hearth	See	A		FK-12 Fan
Support	Detail			Base Pan
				Hearth
				Support
	EB-1 Re-			Access Cover
	ceptacle			Hearth Pan
	Cold Air Box
Side View
Front of
Unit
Base Pan
Hearth Pan				FK-12 Fan
	Detail		A	584-10
Fig. 72 FK-12 Fan Kit placement.
20000584

Remote Controls

Optional remote control units are available to control different functions of the appliance.

Model	Functions Controlled
RC1	ON/OFF
RC2	ON/OFF and Temperature
IMTFK	Wall mounted thermostat control

Ceramic Refractory Panels

1.Remove glass and logs.

2.Insert supports under ceramic hearth panels. (Fig. 73)

3.Remove three (3) screws securing heat shield to combustion dome. (Fig. 74)

4.Place rear ceramic panel in back of unit. (Fig. 75)

5.Place side panels.

6.Replace heat shield, logs and glass.

		Ceramic Support
	Burner	Grate
		Hearth Panel	H101
Fig. 73	Ceramic support.

	Section A
Heat Shield		Heat Shield
		(3) Screws
		Side View
		Section A
	Front View	H103
Fig. 74	Heat shield.

35