Vermont Casting DVRSL, DVRS3, DVRSR Lighting Instructions, To Turn OFF GAS to Fireplace

A.This fireplace has a pilot which must be lit manually. When lighting the pilot follow these instructions exactly.

B.BEFORE LIGHTING smell all around the fireplace area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any fireplace.

•Do not touch any electric switch

•Do not use any phone in your building

•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

•If you cannot reach your gas supplier, call the Fire Department

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, do not try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.

D.Do not use this fireplace if any part has been under water. Immediately call a qualified service technician to inspect the fireplace and to replace any part of the control system and any gas control which has been under water.

1.STOP! Read the safety information above on this label

2.Turn the On/Off switch to Off position or set the thermostat to lowest setting.

3.Turn off all electric power to the fireplace.

4.Open control access panel.

5.Remove glass door before lighting pilot. (See Glass Door Removal).

6.Push in gas control knob slightly and turn clockwise

to "OFF".

7.Wait fifteen (15) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow "B" in the safety information above on this label. If you don't smell gas, go to the next step.

8.Visibly locate pilot by main burner.

9.Turn knob on gas control counterclockwise to "PILOT".

10.Push in control knob all the way and hold in. Immediately light the pilot by repeatedly depressing the piezo spark ignitor until a flame appears. Continue to hold the control knob in for about one

(1) minute after the pilot is lit. Release knob and it will pop back up. Pilot should remain lit. If it goes out, repeat steps 5 through 8.

• If knob does not pop up when released, stop and immediately call your service technician or gas supplier.

• If the pilot will not stay lit after several tries, turn the gas control knob to "OFF" and call your service technician or gas supplier.

11.Turn gas control counterclockwise to "ON" position.

12.Replace glass door.

13.Turn on all electric power to the fireplace.

14.Turn the On/Off switch to On position or set thermostat to desired setting.

15.This valve is equipped with a Hi/Lo feature. Set fireplace input as desired.

TO TURN OFF GAS TO FIREPLACE

F OF

PILOT

O N it