Vermont Casting DVRSL, DVRS3, DVRSR Installation and Operating Instructions

INSTALLATION AND OPERATING

INSTRUCTIONS

This gas appliance should be installed by a qualified installer in accordance with local building codes and with current CAN /CGA- B149 (. 1 or .2) Installation codes for Gas Burning Appliances and Equipment. or for U.S.A Installations follow local codes and/or the current National Fuel Gas Code. ANSI Z223.1.

FOR SAFE INSTALLATION AND OPERATION OF YOUR MAJESTIC DIRECT VENT FIREPLACE PLEASE NOTE THE FOLLOWING:

1 . This fireplace gives off high temperatures and should be located out of high traffic areas and away from furniture and draperies.

2.Children and adults should be alerted to the hazards of the high surface temperatures of this fireplace and should stay away to avoid burns or ignition of clothing.

3.CAUTION: Due to high glass surface temperature children should be carefully supervised when they are in same room as your fireplace.

4.Under no circumstances should this fireplace be modi- fied. Parts having to be removed for servicing should be replaced prior to operating this fireplace again.

5.Installation and any repairs to this fireplace should be carried out by a qualified service person. A profes- sional service person should be contacted to inspect this fireplace annually. Make it a practice to have all of your gas fireplaces checked annually. More frequent cleaning may be required due to excess lint and dust from carpeting, bedding material, etc.

6.Control compartments, burners and air passages in this fireplace should be kept clean and free of dust and lint. Make sure that the gas valve and pilot light are turned off before you attempt to clean this fireplace.

7.The venting system (chimney) of this fireplace should be checked at least once a year and if needed your venting system should be cleaned.

8.Keep the area around your fireplace clear of combusti- ble materials, gasoline and other flammable vapour and liquids. This fireplace should not be used as a drying rack for clothing, nor should Christmas stock- ings or decorations be hung in the area of it.

9.Under no circumstances should any solid fuels (wood, coal, paper or cardboard etc.) be used in this fireplace.

10.The flow of combustion and ventilation air must not be obstructed in any way.

11.Whether the fireplace is installed directly on carpeting, vinyl tile or any combustible material other than wood, this fireplace must be installed on a metal or wood panel extending the full width and depth of the fireplace.

12.This fireplace requires adequate ventilation and combustion air to operate properly.

- 3 -

IMPORTANT:

PLEASE REVIEW THE FOLLOWING CAREFULLY

It is normal for fireplaces fabricated of steel to give off some expansion and/or contraction noises during the start up or cool down cycle. Similar noises are found with your furnace heat exchanger or car engine.

It is not unusual for your Majestic gas fireplace to give off some odour the first time it is burned. This is due to the curing of the paint and any undetected oil from the manufacturing process.

Please ensure that your room is well ventilated - open all windows.

It is recommended that you burn your Majestic fireplace for a least six (6) hours the first time you use it. If optional fan kit has been installed, place fan in the "OFF" position during this time.

LOCATING YOUR MAJESTIC

GAS FIREPLACE

Fig. 1

A)Wall Installation

B)Island Installation (through the wall or vertical)

Note (Fig. 1):

**Island (B) installation is possible as long as the horizontal portion of the vent system (X) does not exceed 20 feet (6100mm). See details in Venting Section.

The minimum clearance between all glass sides and any parallel walls is 3 feet (914mm). A minimum clearance of 3" (76mm) must be maintained from any wall adjacent to one of the glass sides (Fig. 1).