INSTALLATION OF LOGSET and EMBERS
INSTALLING THE GLOWING EMBERS and LOGSET
A bag of ceramic fiber embers is provided for use on the front burner ember tray.
CAUTION: Use only the type of ember material supplied with this appliance. Due to the irregular size of the ember material there may be more than required. Use only a single layer. Do not pile embers. The use of other foreign materials on the burners may create dangerous conditions.
If over time, through cleaning and servicing, these embers require replacement, contact your nearest ENVIROGAS dealer for replacement embers.
1.Carefully remove log from unit. Check to ensure there is no damage. It is very important to install this log in its proper position to insure safe, optimum operating conditions.
2.Place the log set into the firebox with the burnt area forward. Locate the log by seating it down onto the burner tray supports
3.Gently remove the ember material from the plastic bag. Spread a single layer loosely across the rear ember tray. Do not allow any embers to rest against pilot assembly.
4.Spread ember pieces in a single layer evenly across the front burner ember tray, Place a single layer of embers on top of the front burner.
5.Carefully avoid any clumping or large
6.Upon the first light up, watch for ignition to all burner ports. If a long delay is noted:
First, wait for the appliance to cool down
•Open the front door of the appliance.
•Check to carefully reposition the embers making sure that burner ports are not plugged solid or blocked
CAUTION: NEVER OPERATE THIS APPLIANCE WITH THE DOOR REMOVED
REMOVING AND INSTALLING THE BRICK PANELS Open the door. Remove the log set.
STEEL PANEL: Undo the two screws located in the top two corners of the firebox. Tilt forward at top corners and pull out. Installation is the reverse.
OPTIONAL CERAMIC PANELS
Remove the burner top from the firebox, this will prevent possible damage to the ceramic panels.
Place the back panel on the rear support ledge making sure that the panel is centered on the back of the firebox.
Install side panels into firebox insuring that the rear edge of the side panel supports the rear panel from falling forward. Install the two retaining clips (one on each side) in the front upper corner in the holes provided.
14