Garland Convection Microwave Oven installation instructions Installation, Electrical Connections

Page 7

INSTALLATION Continued

C. Install the interconnecting flue parts, carefully following the instructions contained in the stacking kit. Pay particular attention to the type of ovens you are stacking and be sure to follow the corresponding instructions.

D. Check leveling of unit four (4) ways (using a common carpenter’s level on the rack inside the oven).

E. Maintain clearance from combustibles.

CAUTION: Disconnect Both Unites from electrical Supply Before Servicing.

Electrical Connections

Before attempting the electrical connection, the rating plate should be checked to ensure that the unit’s electrical characteristics and the supply electrical characteristics agree.

Installation of the wiring must be made in accordance with U.L.  Commercial Electric Cooking Appliance Standards, Local and/or National Electrical Code, ANSI/NFPA -, or the Canadian Electrical Code, CSAC . as applicable.

1.Switch panel size

2.Overload protection

3.Wire type

4.Wire size

5.Temperature limitations of the wires

6.Method of connection (Cable, Conduit, etc.)

The service line will enter through the rear of the unit and is to be connected to the terminal block (see diagram). The terminal block is accessed by removing the lower front cover. Removal of the body side is not necessary.

Input voltage and phasing must match the units voltage and phasing. Wiring diagram is attached to the main back of each oven. Visually check all electrical connections. Energize electric service to units. The range is wired standard for three phase connections. If it is necessary to change to single phase, please refer to wiring diagram attached to the rear of the oven. Service and unit voltage must agree.

Part # 1955203 (12/06)

Page 7

Image 7
Contents Installation 1955203 12/06 Table of Contents MCO-ED-10 Dimensions and SPECIFICATIONS, MCO ED/ES 10/2044-1/2 1130mm Dimensions and SPECIFICATIONS, MCO ED/ES 10/20 SIntroduction InstallationElectrical Connections InstallationLights Operating InstructionsModes Fan SpeedOff Modes TemperatureTimer Operating InstructionsController Keys Core Probe Operation Fahrenheit/CelsiusOperating the Controls Cook-N-Hold OperationManual Cooking Setting Setback FeaturePress the same product key 1-9 again PR-3 will be displayed Manual cooking using Cook-N-HoldSet the first cooking temperature using the dial Press START/CANCEL to begin manual cookingVerifying Hold Time Master Cooking Using The Product Keys MasterCooking With The Shelf Timer Master Press the START/CANCEL key to switch between F and CPreheat oven thoroughly approx minutes before use Performance RecommendationsPerformance Recommendations PROBLEM/SOLUTIONSTime Cooking GuideTime in Hours Cook and HoldFan Area Maintenance Cleaning and MaintenanceExterior Cleaning Interior CleaningMotor Care Cleaning and MaintenancePage Page Pour ralenti au est four le quand rôtissage, de ou Ventilateur Le .commande de tableau du DownSuite Nettoyage ET Entretien Moteur Du EntretienNettoyage ET Entretien Ventilateur Du Zone La De MaintenanceIntérieur Nettoyage Heures EN Temps Chaud AU Maintien ET CuissonViandes Caisson DE GuidePROBLÈMES/SOLUTIONS Cuire ’UTILISATION RecommandationsLa de et l’humidité de particulier en produits Suite D’UTILISATION Instructions Au Maintien De Temps Du cationVérifi Pour START/CANCEL toucheMaster Niveau De Minuterie La Avec Cuisson Master ChaudMaster Hold-N-Cook Fonction La De Hold DEL la SET touche la sur AppuyezTemp DEL la SET touche la sur Appuyez Chaud Au Maintien Et CuissonSetback fonction la de Réglage Consigne de point au retourErmiqueTh Sonde La Avec Fonctionnement Fahrenheit/Celsius Commandes Des UtilisationPorte la Avec .porte la d’entrouvrir l’utilisateur à Température Off D’arrêt Mode EnAgechauff le pas commande ne minuterie La Nota MinuterieDémarrage ’UTILISATION InstructionsÉclairage Ventilateur Du VitesseÉlectriques Connexions Suite InstallationLfi de Type Électrique, branchement le commencer de AvantMm 152 po 6 Arrière mm 25 po 1 Côtés Roulettes De Équipées Rôtissoires Des InstallationSignalétique Plaque Dégagements60/50Hz tr/mn, 1725/1440 et 1140/950 10/20 ED/ES MCO SPÉCIFICATIONS, ET Dimensions1791 1/2-70 965 711 610 736 Matière DES Table 12/06 1955203 n Pièce Inc Industries, Commercial Garland