Fahrenheit/Celsius,  seconds | Garland Convection Microwave Oven

OPERATING INSTRUCTIONS Continued

will indicate “DOOR”. This is a patented safety feature. Pressing the COOL DOWN key again will turn the LED oﬀ and stop this mode. Pressing the ON/OFF key will also cancel Cool down. Cool Down is not active during a cook.

When the ON/OFF switch is pressed to turn the oven oﬀ and the oven was above °F (°C), the oven will go into an AUTO COOL DOWN mode. In Auto cool Down, the oven will run the fan on high until the oven cavity drops below °F (°C). During this time the display will indicate “AUTO”. When the oven temperature drops below °F (°C) the oven turns oﬀ. This feature protects the oven motor from premature failure. Optimal cool-down will be achieved with door open slightly.

Fahrenheit/Celsius

Factory default is Fahrenheit (F). To change to Celsius (C), press and hold in the “Phantom Key” located to the right of “Cook/Hold” key. “F” appears in the display. Continue to hold until “C” is displayed and then release the “Phantom key”

Operating the Controls

Setting the cook temperature and time are done in the same manner. Pressing the SET key will light the TEMP LED. The operator then sets the temperature by rotating the dial on the controller until the desired temperature is shown on the display. Pressing the SET key a second time lights the TIME LED and allows the operator to select the desired cook time as shown on the display. Pressing the SET key a third time ends the programming.

Pressing the START/CANCEL key will start the timing cycle. The display will count down from the Set time in minutes and seconds (solid colon) or hours and minutes (blinking colon) then minutes and seconds. When the cycle is completed, pressing this key will also cancel the “DONE” prompt. To cancel a timing cycle in progress, press and hold the START/CANCEL key for

seconds.

Cook-N-Hold Operation

Pressing the COOK/HOLD ( and  Controllers Only) key activates the Cook-N-Hold mode and lights is LED. To verify the proper hold temperature has been selected, press the SET key twice. The display will show the hold temperature. At the end of the cook cycle, an audible alarm will sound, the display will ﬂash “DONE” and change to count “UP” the time the oven is on hold. The oven will switch to the programmed hold temperature.

Setting the cook temperature, hold temperature and time are done in the same manner. Pressing the SET key will light the TEMP LED. The operator then sets the temperature by rotating the dial on the controller until the desired temperature is shown on the display. Pressing the SET key a second time will light the HOLD LED and allows the operator to select the desired hold temperature as shown on the display. Pressing the SET key a third time lights the TIME LED and allows the operator to select the desired cook time as shown on the display. Pressing the SET key a fourth time ends the programming.

Pressing the START/CANCEL key will start the timing cycle. When the cycle is completed, pressing the key will also cancel the “DONE” prompt. To cancel a timing cycle in progress press and hold the START/CANCEL key for  seconds.

Core Probe Operation

The Core Probe option ( Controller Only) is only active when the core probe is plugged into its connector. To set the core temperature, ﬁrst plug the core probe into its connector. The display will indicate “” and the CORE TEMP LED will be on. The operator then sets the temperature by rotating the dial on the controller until the desired temperature is shown on the display. Pressing the SET key stores the core temperature and starts the cooking process.

Part # 1955203 (12/06)

Page 11