Zanussi ZDT 6454 user manual Installation, Water connection, Full load 12 standard place settings

Page 23

rinse aid respectively and using the test pro- gramme (see "Consumption values").

Full load: 12 standard place settings

Amount of detergent required Rinse aid setting

5 g + 25 g (Type B) position 4 (Type III)

Upper basket

Cutlery basket

Lower basket

cup racks: position A

Installation

WARNING!

Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or compe- tent person.

Water connection

WARNING!

The dishwasher must not be connected to open water appliances or instantaneous water heat- ers. This dishwasher may be fed with either hot (max. 60°) or cold water. Nevertheless we ad- vise you a cold water supply.

Image 23

Contents Dishwasher ZDT Contents Correct use Safety informationGeneral safety Child safetyFunctions buttons InstallationControl panel Indicator lights Deactivation/activation of the audible sig- nals Audible signalsSelect and start a washing programme End of the washing programme Cancelling the delay startCancel a washing programme in progress Interrupt a washing programme in pro- gressType of load Washing programmesProgramme Degree of soilSet the water softener When using tablets that integrate rinse aid and detergentFirst use Water hardness Mmol/l Setting the water softener manually see tableSetting the water softener electronically see table Dishwasher is factory set at levelExamples Filling with dishwasher saltOnly before filling with Filling with rinse aid Adjusting the dosage of rinse aidAre of limited suitability Loading cutlery and dishesLower basket Adjusting the height of the upper basketMaximum height of the dishes Upper basket Use of detergent Unloading the dishwasher Care and cleaningCleaning the filters Prolonged periods of non- operation Cleaning the spray armsExternal cleaning Internal cleaningPackaging material Frost precautionsEnvironmental concerns Moving the machineSomething not working Fault code and malfunctionPossible cause and solution Wash results are not satisfactory Hints for test institutes Technical dataConsumption values Water connection InstallationFull load 12 standard place settings Water inlet hose with safety valve Electrical connection Drain hoseLevelling Guarantee conditionsEuropean Guarantee Fitting under a counterPage Page Page Page Page 156997520-00-21022007 Subject to change without notice