Something not working
The dishwasher will not start or stops during operation.
Certain problems are due to the lack of simple maintenance or oversights, which can be
solved with the help of the indications described in the chart, without calling out an engineer. Switch off the dishwasher and carry out the fol- lowing suggested corrective actions.
Fault code and malfunction
•1 intermittent audible signal
•continuous flashing of the light of the running programme
•1 flash of the "end of programme " indicator
light
The dishwasher does not fill with water.
•2 intermittent audible signals
•continuous flashing of the light of the running programme
•2 flashes of the "end of programme " indicator
light
The dishwasher will not drain.
•3 intermittent audible signals
•continuous flashing of the light of the running programme
•3 flashes of the "end of programme" indicator light
The programme does not start.
Possible cause and solution
•The water tap is blocked or furred with limescale. Clean the water tap.
•The water tap is turned off. Turn the water tap on.
•The filter (where present) in the threaded hose fit- ting at the water inlet valve is blocked.
Clean the filter in the threaded hose fitting.
•The water inlet hose has not been correctly laid or it is bent or squashed.
Check the water inlet hose connection.
•The sink spigot is blocked. Clean out the sink spigot.
•The water drain hose has not been correctly laid or it is bent or squashed.
Check the water drain hose connection.
Close the water tap and contact your local Service Force Centre.
•The dishwasher door has not been properly closed. Close the door.
•The main plug is not plugged in. Insert the mains plug.
•The fuse has blown in the household fuse box. Replace the fuse.
Once these checks have been carried out; switch on the dishwasher. The programme will
20
continue from the point at which it was inter- rupted.