Kyocera FS-1700 user manual Error Messages, Indicators and Messages

		5.5 Indicators and Messages
Message		Corrective Action
 5 		Mechanical error (n=<, >, ;, ...)-Call a service person. The printer does not oper-
$=<>;?!		ate when a message beginning with $ is displayed. The total number of pages
		printed is also indicated.
 5 		Controller error (n=<, >, ;, ...)-Call a service person. The printer does not oper-
=<>;?!		ate when a message beginning with  is displayed. The total number of pages
		printed is also indicated.
Error Messages
Table 5.3 Error Messages
Message		Corrective Action
* 5		The total amount of data received by the printer exceeds the printer's internal
	.,.+$	memory. Try adding more memory (expansion RAM). Press the CONTINUE key to
		resume printing. You can abandon printing by the CANCEL key.
  5		The data transferred to the printer was too complex to print on a page. Press the
	.,.+$	CONTINUE key to resume printing. (The page may break in some pages.)<R>You
		can abandon printing by the CANCEL key.
		Note: After this message has been displayed, Page protect mode will be On.
		To maintain optimum use of memory during printing, display
		-  from the control panel, and re-select .
		See the last page in this manual.
: $		Current print processing cannot continue.
	.,.+$	To print out a error report, display - : from the mode
		select menu, and select .
		Press the CONTINUE key to resume printing. You can abandon printing by the
		CANCEL key.
*$*3	 	The memory card is accidentally removed from the printer's memory card slot dur-
,  		ing reading. If you continue reading the memory card, insert the same memory
		card into the slot again. The printer again reads it from the beginning of the data.
		Note: We recommend that you follow the reading procedure from the begin-
		ning to ensure correct reading of the memory card.
, 0 		You have inserted the wrong memory card when the ,  mes-
*$*3		sage was displayed. Remove the wrong memory card from the printer's memory
		card slot and insert the correct memory card. The printer again reads it from the
		beginning of the data.
 		This message appears when the printer is in the ready state and the memory card
*$*3		is not formatted, and therefore cannot be read or written. Follow the procedure
		on Section 2.10. to format the card.
  "		This message appears when the printer is in the ready state and the battery in the
*$*3		memory card is low. You can still enter the memory card mode, but the battery
		should be changed as soon as possible.
# 		This message appears when the printer is in the ready state and the battery in the
*$*3		memory card is dead, or there is no battery at all. It is not possible to use the mem-
		ory card mode until you insert a good battery in the card.

5-9