
5.5 Indicators and Messages
Message | Corrective Action |
*$*3 && | This message appears when an error occurs during access to the memory card |
.,.+$ | using the PRESCRIBE IIe RWER (ICCD) command or from the printer's control |
| panel. Look at the error code given in place of && and refer to the corresponding |
| description given below. Please note that error codes of <'and above only result |
| when memory card operations are done fromthe control panel. |
| <>:Data or memory card capacity is too large. |
| • This error code appears if an attempt is made to write more than 32 MB of data |
| to a memory card or if the capacity of the memory card installed in the printer |
| is more than 32 MB. Decrease the data being written to the memory card to |
| less than 32 MB. Note that only memory cards of 32 MB and less can be used |
| by this printer. |
| • This error code appears when a data name not existing on the memory card is |
| specified. |
| Check the data names on the memory card. |
| <;: The memory card does not meet specifications. This memory card cannot |
| be used by this printer. Insert a memory card which can be used by this printer. |
| (See "Memory Cards" of Chapter 2.) |
| <?: The memory card is not a JEIDA card. Only JEIDA Ver. 4.2 memory cards can |
| be used by this printer. |
| <: The card is an |
| <: There is no battery in the memory card. Replace the battery in the memory |
| card with a new one. |
| <!: The memory card is |
| memory card. |
| <@: The memory card requires formatting. Format the memory card from the |
| control panel. |
| <': The capacity of the memory card is insufficient. This error code appears |
| when an attempt is made to write more data on the memory card than available |
| memory. To halt the writing of data, first stop data transmissions from the com- |
| puter, and then the printer's CONTINUE key. Press the FORM FEED key if the mes- |
| sage will appear in the message display. The message display will |
| return to reading . |
| >>: The memory card is full of data items. The number of data items which can |
| be written on the memory card is limited to 127. Pressing the CONTINUE key will |
| restore the message in the message display. |
| >?: This is a logical error. Try substituting another flash memory card. |
| >@: The flash memory card cannot be written due to insufficient printer memory. |
| Either delete unnecessary macros and/or fonts stored in the printer, or expand the |
| printer's available memory. |
| >A: This is a write error. Try substituting another flash memory card. (Error codes |
| >? through >A apply only to flash memory cards.) |
|
|
The amount of memory available for the fonts header parts of font is too small to | |
| load more fonts. Try deleting unnecessary fonts and macros. |
|
|
,B | This message is displayed when you attempt to use the printer's control panel to |
| change the environmental settings on the interface from which data are presently |
| being received. |
|
|