Frigidaire FGEF304DKW, FGEF304DKB Care and Cleaning of Stainless Steel, Changing Oven Light

Page 33

CLEANING RECOMMENDATIONS FOR THE CERAMIC GLASS COOKTOP (CONTINUED)

Plastic or foods with a high sugar content:

These types of soils need be removed immediately if spilled or melted onto the ceramic cooktop surface. Permanent damage (such as pitting of the cooktop surface) may occur if not removed immediately. After turning the surface elements OFF, use a razor blade scraper or a metal spatula with a mitt and scrape the soil from the hot surface (as illustrated). Allow the cooktop to cool, and use the same method for heavy or burned on soils.

Do not use the following on the ceramic glass cooktop:

Do not use abrasive cleaners and scouring pads, such as metal and some nylon pads. They may scratch the cooktop, making it more difficult to clean.

Do not use harsh cleaners, such as chlorine bleach, ammonia or oven cleaners, as they may etch or discolor the cooktop.

Do not use dirty sponges, cloths or paper towels, as they can leave soil or lint on the cooktop which can burn and cause Special Caution for Aluminum Foil and Aluminum Cooking Utensils

Aluminum foil

Use of aluminum foil will damage the cooktop. Do not use under any circumstances.

Aluminum utensils

Since the melting point of aluminum is much lower than that of other metals, care must be taken when aluminum pots or pans are used. Pans that boil dry may permanently damage cooktop by breaking, fusing to, or marking it.

CARE & CLEANING

CARE AND CLEANING OF STAINLESS STEEL

Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the appearance of stainless parts. Refer to the General Care & Cleaning table for detailed cleaning instructions.

CHANGING OVEN LIGHT

CAUTION

Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the oven light on during a self-cleaning cycle. High temperature will reduce lamp life.

On some models an interior oven light will turn on automatically when the oven is opened. The oven light may be turned on when the door is closed by using the oven light switch located on the Electronic Oven control. The oven light bulb is covered with a glass shield held in place by a wire holder. THIS GLASS SHIELD MUST ALWAYS BE IN PLACE WHEN THE OVEN IS IN USE.

CAUTION

BE SURE OVEN IS COOL

To Replace the Light Bulb:

1.Turn the power off at the main source.

2.Wear a leather-faced glove for protection against possible broken glass.

3.Replace bulb with a 40 Watt appliance bulb only.

4.For self-cleaning oven, press wire holder to one side to release glass shield, change bulb and be sure to replace glass shield.

33

Image 33 Contents
Use &Care Welcome & Congratulations Register Your ProductPlease Carefully Read and Save These Instructions Definitions Important Safety InstructionsImportant Instructions for Using Your Cooktop Important Safety Instructions for Using Your Oven Important Safety Instructions for Cleaning Your OvenFor Glass Cooktop only Your built-in range Features Features AT a GlanceBefore Setting Surface Controls About the radiant surface elements Using proper cookwareAbout the ceramic glass cooktop Cookware material typesSetting Surface Controls Single radiant surface elementsTo Operate the Single Radiant Surface Elements To Operate the Dual Surface Element Dual Surface Radiant ElementKeep warm zone Keep warm zone recommended food settings table Food ItemBefore Setting Oven Controls Types of oven racks Effortless oven rack system To assemble the Effortless Oven Rack systemNever pick up hot oven rack parts Control pad features Setting Oven ControlsTemperature Visual Display Minimum and Maximum Control PAD SettingsFeature Minimum TEMP. /TIME Maximum TEMP. /TIME BAKE, Convection BAKE, Convection Roast and PizzaSetting Continuous Bake or 6 Hour Energy Saving Setting the ClockSetting Temperature Display Fahrenheit or Celsius Changing Between 12 or 24 Hour Time of DAY DisplaySetting Minute Timer Setting Lockout FeatureSetting Silent Control Operation Setting ADD 1 Minute FeatureSetting Bake Setting Quick PreheatTo set the quick preheat with an oven temperature of 375F To set the Bake Temperature to 375FConvection Baking Tips Setting Convection Bake lower oven onlyBenefits of Convection Bake Air circulation during Convection BakeSetting Convection Roast lower oven only Setting Convection Convert lower oven onlyTo set a Convection Roast Temperature of 375F Convection Roasting TipsTo set a Convection Broil Temperature of 500F Convection Broiling TipsElectric Oven Convection Broiling Table Recommendations Setting Delay Start Setting Bake TimeWhen the timed bake finishes BAKE, Convect BAKE, Bake Time and DelayCancel Setting BroilBroiling Tips To set a Broil of 500FSetting Pizza Setting Chicken NuggetsDelayed Bake Time Setting Keep WarmKeep Warm Tips To set Keep WarmOven will turn on and begin heating Oven Light Adjusting Oven Temperature SELF-CLEANING SELF-CLEANING Adhere to the following cleaning precautions What to Expect during CleaningSetting SELF-CLEAN Cycle Time Length When the Self-Clean Cycle is CompletedStopping or Interrupting a Self-Cleaning Cycle Cleaning Various Parts of Your Appliance Care & Cleaning Cleaning ChartCeramic Glass Cooktop Cleaning & Maintenance Care & CleaningCleaning Recommendations for the Ceramic Glass Cooktop For light to moderate soilCare and Cleaning of Stainless Steel Changing Oven LightBe Sure Oven is Cool OFF Lower Oven Door Removing and Replacing the LiftFirmly grasp both sides of oven door along the door To Remove Oven DoorRemoving and Replacing the LIFT- OFF Upper Oven Door Oven baking Occurrence Possible CAUSE/SOLUTION Soil not completely removed after self- cleaning cycle Self-cleaning cycleScratches or Abrasions onPage Major Appliance Warranty Exclusions This warranty does not cover the followingDisclaimer of Implies Warranties Limitation of Remedies