Frigidaire 318200858 Setting the Controls for Self-Clean Cycle, To Remove and Replace Oven Door

Page 16

General cleaning (continued)

Cleaning the Self-Clean Oven (some models, continued)

Do Hand

Clean

Frame

Do Hand

Do Not Hand

Clean Door

Clean Seal

Preparing the Oven for Self-Cleaning

1.Remove all excess spillovers in the oven cavity before starting the self-cleaning cycle. To clean, use hot soapy water and a cloth. Large spillovers can cause heavy smoke or fire when subjected to high temperatures. DO NOT allow food spills with a high sugar or acid content (such as tomatoes, sauerkraut, fruit juices or pie filling) to remain on the surface as they may cause a dull spot even after cleaning.

2.Clean any soil from the oven frame and the door liner (see illustration). These areas heat sufficiently during self-cleaning cycle to burn soil on. Clean with soap and water.

3.Remove the broiler pan and insert, all utensils and any foil. These items do not withstand high cleaning temperatures

4.Oven racks may be left in the oven or may be removed. If they go through the clean cycle, their color will turn slightly dull. After the cycle is completed and the oven has cooled, rub the sides of the racks with wax paper or a cloth containing a small amount of baby oil or salad oil. This will make the racks glide easier.

What to Expect During Cleaning

While the oven is in operation, the oven heats to temperatures much higher than those used in normal cooking. Sounds of metal expansion and contraction are normal. Odor is also normal as the food soil is being removed. Smoke may appear through the oven vent, located on the top of the control panel.

If heavy spillovers are not wiped up before cleaning, they may flame and cause more smoke and odor than usual. This is normal and safe and should not cause alarm. If available, use an exhaust fan during the self-cleaning cycle.

NOTE: A smoke eliminator in the oven vent converts most of the soil into a colorless vapor.

Setting the Controls for Self-Clean Cycle

For the setting of the clean cycle, refer to Timer or Electronic Oven Control section.

To Remove and Replace Oven Door

1.Open the door to the fully opened position.

2.Pull up the lock located on both hinge supports and engage it in the hook of the hinge levers. You may have to apply a little downward pressure on the door to pull the locks fully over the hooks.

3.Grab the door by the sides, pull the bottom of the door up and toward you to disengage the hinge supports.

Keep pulling the bottom of the door toward you while rotating the top of the door toward the range to completely disen- gage the hinge levers.

4.Proceed in reverse to reinstall the door.

Make sure the hinge supports are fully engaged before unlocking the hinge levers.

The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.

Lock in normal position

Lock engaged for door removal

HINGE SLOT Door re- moved from the range

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Slide-in Models Product Registration Register Your ProductVersión en español Record Your Model and Serial NumbersImportant Safety Instructions Important Safety Instructions Selecting Surface Cooking Utensils Canning Tips Information Burner unit may also be used.Fat frying Prevent damage to cooktop and burner gratesProper Burner Adjustments Liquefied Petroleum Propane Gas ConversionFlame Size Flame size Type of CookingSetting Surface Controls Before Setting Oven ControlsSetting Oven Controls Oven Vent LocationBefore Setting Warmer Drawer Controls some models Setting Warmer Drawer Controls some modelsTemperature Selection Warmer Drawer Recommended Food Settings ChartConvection Cooking some models Convection Roasting some modelsOven Baking Baking Problems and Solutions ChartAir Circulation in the Oven Broiling Cleaning Various Parts of Your Range General Cleaning Surfaces How to Clean To Clean the Tempered-glass Cooktop some models To Clean the Burner GratesTo Clean the Contoured Burner Pans For sugary spilloversCleaning the Self-Clean Oven some models To Clean the Buner CapAdhere to the following cleaning precautions To Replace the Burner Base and the Burner CapSetting the Controls for Self-Clean Cycle Do Hand Clean Frame Do Not Hand Clean Door Clean SealPreparing the Oven for Self-Cleaning What to Expect During CleaningRemovable Outer Door Glass Panel some models To Remove and Replace Warmer Drawer some modelsAvoid Service Checklist Before you call for service read thisInstallation Changing Oven LightAvoid Service CheckList Have sufficient room for range clearanceRange does not Operate Surface UnitsGlass Cooktop Cleaning in the General Cleaning section Brown streaks or specksTemperature in the Electronic Oven Control section Avoid Transportation Damage to your RangePoor Baking Results Poor baking resultsRange Warranty Cuisinières encastrables Produit Enregistrement duEnregistrez votre appareil Mesures DE Sécurité Importantes Mesures DE Sécurité Importantes suite Conservez CES Instructions Casseroles et sous-plats particuliers Conseils et renseignements sur la mise en conserveDimension de la flamme Dimension de la flamme Type de cuissonConversion au propane Bon réglage des brûleursRéglage des commandes des brûleurs de surface Avant de régler les commandes du fourRéglage des commandes du four Installation des grillesRéglage de la commande du tiroir réchaud certains modèles Réglage de la commande du thermostatDisposition de la grille du tiroir-réchaud Pour faire fonctionner le tiroir-réchaudCuisson par convection certains modèles Rôtissage par convection certains modèlesSélection du réglage de la température Tableau des réglages recommendés pour le tiroir-réchaudCuisson au four Circulation de l’air dans le fourCuisson au gril Nettoyage des composantes de la cuisinière Nettoyage généralSurfaces Méthodes de nettoyage Nettoyage général suite Pour les renversements de sucreNettoyage des grilles de brûleurs Nettoyage des cuvettes de brûleursNettoyage du four autonettoyant certains modèles Nettoyage des couvercles de brûleursRemise en place de la base du brûleur et du couvercle Prenez les précautions de nettoyage qui suiventRéglage des commandes du four pour un cycle autonettoyant Enlever et réinstaller de la porteNettoyage du four autonettoyant certains modèles, suite Préparation du four avant lautonettoyagePorte avec vitre extérieure démontable certains modèles Pour retirer et replacer le tiroir-réchaud certains modèlesRemplacement de lampoule du four Avant d’appeler un technicien de service lisez ce qui suitListe des vérifications préventives Tiroir de rangement certains modèlesLA Cuisinière NE Fonctionne PAS Liste des vérifications préventives suiteSurface DE Cuisson Surface DE Cuisson Vitrocéramique Certains Modèles Surface DE Cuisson Avec Brûleurs À GAZ Certains ModèlesÉvitez d’endommage l’appareil durant son transport Mauvais Résultats DE Cuisson AU FourCuisson AU Gril Autnettoyage DU Four Certains ModèlesGarantie DE LA Cuisinière
Top Page Image Contents