GE EGR3000 installation instructions Safety, Top-of-Range Cookware, Case of Power Failure

Page 9

www.GEAppliances.com

Top-of-Range Cookware

Safety

Aluminum: Medium-weight cookware is recommended because it heats quickly and evenly. Most foods brown evenly in an aluminum skillet. Use saucepans with tight- fitting lids when cooking with minimum amounts of water.

Cast-Iron:If heated slowly, most skillets will give satisfactory results.

Enamelware: Under some conditions, the enamel of some cookware may melt. Follow cookware manufacturer’s recommendations for cooking methods.

Glass: There are two types of glass cookware—those for oven use only and those for top-of-range cooking (saucepans, coffee and teapots). Glass conducts heat very slowly.

Heatproof Glass Ceramic: Can be used for either surface or oven cooking. It conducts heat very slowly and cools very slowly. Check cookware manufacturer’s directions to be sure it can be used on gas ranges.

Stainless Steel: This metal alone has poor heating properties and is usually combined with copper, aluminum or other metals for improved heat distribution. Combination metal skillets usually work satisfactorily if they are used with medium heat as the manufacturer recommends.

Instructions Operating Instructions

Stove Top Grills (on models with sealed burners)

Do not use stove top grills on your sealed gas burners. If you use the stove top grill on the sealed gas burner, it will cause incomplete combustion and can result in exposure to carbon monoxide levels above allowable current standards.

This can be hazardous to your health.

 

Wok This Way (on models with sealed burners)

 

We recommend that you use a 14 ″ or smaller

Do not use a flat-bottomed wok on a

 

flat-bottomed wok. Make sure the wok bottom

support ring. Placing the ring over the

Use a flat-bottomed wok.

sits flat on the grate. They are available at your

burner or grate may cause the burner

local retail store.

to work improperly, resulting in carbon

 

Only a flat-bottomed wok should be used.

monoxide levels above allowable standards.

This could be dangerous to your health.

 

In Case of Power Failure

In case of a power failure, you can light

Surface burners in use when an electrical

the gas surface burners on your range with

power failure occurs will continue to

a match. Hold a lit match to the burner,

operate normally.

then push in and turn the control knob

 

to the LITE position. Use extreme caution

 

when lighting burners this way.

 

9

Installation Instructions Troubleshooting Tips Consumer Support

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Write the model and serial numbers here Model # Serial # RangesSelf-Cleaning GasAll ranges can tip and injury could result ANTI-TIP DeviceImportant Safety Notice Instructions Surface Burners Cook Meat and Poultry THOROUGHLY… Instructions Operating Instructions SELF-CLEANING OvenInstructions Using the gas surface burnersInstructions Operating ConsumerSafety Case of Power FailureTop-of-Range Cookware Using the oven controls Consumer Support Troubleshooting TipsInstallation Instructions Oven Control, Clock and Timer Features and Settings Consumer Support Using the ovenPreheating and Pan Placement How to Set the Oven for Baking or RoastingTips Aluminum FoilHow to Set the Oven for Broiling Broiling GuideHI Broil Installation Using the clock and timerTo Set the Timer To Set the ClockTo Cancel the Timer To Reset the TimerTouch the Kitchen Timer ON/OFF End of Cycle Tones on some modelsHow to Set a Delayed Start and Automatic Stop Using the timed baking and roasting featuresSpecial features of your oven control Safety InstructionsHour Shut-Off Safety Instructions Using the Sabbath Feature. on some modelsHow to Set for Regular Baking/Roasting Designed for use on the Jewish Sabbath and HolidaysHow to Exit the Sabbath Feature Instructions Troubleshooting Tips Consumer Support Adjust the oven thermostat-Do it yourselfTo Adjust the Thermostat Type of margarine will affect baking performanceUsing the self-cleaning oven Before a Clean CycleHow to Set the Oven for Cleaning To Stop a Clean Cycle How to Delay the Start of CleaningAfter a Clean Cycle Tips Consumer SupportStandard Twin Burner Assemblies on some models Care and cleaning of the rangeSafety Replacement After cleaningBurner caps Burner headsBurner Grates Troubleshooting Tips Consumer SupportCooktop Surface To OrderLift-Off Oven Door Troubleshooting TipsOven Bottom Broiler Pan and GridRemovable Storage Drawer on some models Removable Kick Panel on some modelsLower Control Panel Front Manifold Panel and Knobs Oven Air VentsOven Shelves Oven Light ReplacementDo not remove any screws to remove the cover To replace coverPart Included For Your SafetyTools YOU will Need Materials YOU MAY NeedInstallation Instructions Dimensions and Clearances Location ANTI-TIP DeviceProvide Adequate GAS Supply Connect the Range to GASInstallation Instructions Rigid Pipe Hookup Options Pressure regulator Manifold pipe Electrical Requirements Electrical ConnectionsCheck Ignition of Surface Burners Seal the OpeningsCheck Ignition of Oven Burner To remove the oven bottom Leveling the RangeWhen ALL Hookups are Completed Installing the ANTI-TIP DeviceProblem Possible Causes What To Do Before you call for service…See the Care and cleaning of the range section See the Using the clock and timer sectionSee the Installation of the range section Oven temperatureClean cycle After a clean cycle Oven not clean afterExcessive smoking Oven door will notClock flashes Power outageEmitting from the vent Strong odorOperating Instructions Safety Instructions We’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Page Consumer Support Looking For Something More? AccessoriesOperating Instructions Safety InstructionsGE Will Replace What GE Will Not CoverWhat Camco Will Not Cover Camco Will ReplaceParts and Accessories Schedule ServiceConsumer Support GE Appliances Website Real Life Design Studio

EGR3000 specifications

The GE EGR3000 is a cutting-edge gas turbine engine designed to meet the demands of modern power generation and transportation applications. This innovative engine showcases a range of advanced features and technologies that enhance its performance, efficiency, and reliability.

One of the key characteristics of the EGR3000 is its exceptional efficiency. The engine employs an advanced thermodynamic cycle, which incorporates a high compression ratio and an innovative cooling design. This efficiency is particularly important in reducing fuel consumption and emissions, making it an environmentally friendly option compared to traditional gas turbines. The EGR3000 boasts a thermal efficiency rating that places it among the highest in its class.

The EGR3000 utilizes a dual-fuel capability, allowing it to operate on a variety of fuels. This flexibility is crucial for operators looking to optimize their fuel use based on availability and cost, adding to the engine's versatility. Additionally, the engine is designed to accommodate both natural gas and liquid fuels, thereby enhancing its operational range.

Another notable feature is the engine's advanced modular design. This allows for easier maintenance and quicker turnaround times, minimizing downtime and operational costs for power plants and industrial facilities. The modular components can be replaced or serviced individually, which simplifies maintenance procedures and enhances overall reliability.

In terms of technology, the EGR3000 incorporates sophisticated materials and coatings that improve thermal resistance and durability. High-performance blades and combustion chambers are designed to withstand extreme temperatures, resulting in longer service life and reduced maintenance frequency. The engine also employs digital control systems that optimize performance parameters in real-time, ensuring peak efficiency under varying load conditions.

Emissions control is a critical aspect of the EGR3000's design. It features advanced combustion technology that minimizes NOx and CO2 emissions, aligning with stringent environmental regulations. The engine's design enables it to operate with lean-burn technology, further supporting reduced environmental impact.

Overall, the GE EGR3000 stands out as a powerful and efficient gas turbine solution. Its combination of high efficiency, fuel flexibility, modular design, and advanced emission control technologies makes it an ideal choice for various applications, including power generation and industrial processes. As energy demands continue to evolve, the EGR3000 positions itself as a reliable and forward-thinking solution for today’s energy landscape.
Top Page Image Contents