Instructions
Using the clock and timer.
Not all features are on all models.
Instructions Safety
Make sure the clock is set to the correct time of day.
To Set the Clock
The clock must be set to the correct time of day for the automatic oven timing functions to work properly. The time of day cannot be changed during a timed baking or
Touch the CLOCK pad.
Touch the number pads.
Touch the number pads the same way you read them. For example, to set 12:34, touch the number pads 1, 2, 3 and 4 in that order.
If number pads are not touched within one minute after you touch the CLOCK pad, the display reverts to the original setting. If this happens, touch the CLOCK pad and reenter the time of day.
Touch the START pad until the time of day shows in the display. This enters the time and starts the clock.
To check the time of day when the display is showing other information, simply touch the CLOCK pad. The time of day shows until another pad is touched.
Tips Installation Instructions Operating
The timer is a minute timer only.
The CLEAR/OFF pad does not affect the timer.
To Set the Timer
The timer does not control oven operations. The maximum setting on the timer is 9 hours and 59 minutes.
Touch the KITCHEN TIMER ON/OFF pad.
Touch the number pads until the amount of time you want shows in the display. The maximum number of minutes that can be entered is 60. To set additional time, you will need to set it by hours and minutes.
For example, to enter 1 hour and 30 minutes, touch 1, 3 and 0 in that order.
If you make a mistake, press the KITCHEN TIMER ON/OFF pad and begin again.
Touch the START pad. After pressing the START pad, SET disappears; this tells you the time is counting down, although the display does not change until one minute has passed.
When the timer reaches :00, the control will beep 3 times followed by one beep every 6 seconds until the KITCHEN TIMER ON/OFF pad is touched.
The 6 second tone can be canceled by following the steps in the Special features of your oven control section under Tones at the End of a Timed Cycle.
Troubleshooting
To Reset the Timer
If the display is still showing the time remaining, you may change it by touching the KITCHEN TIMER ON/OFF pad; then touch the number pads until the time you want appears in the display.
If the remaining time is not in the display (clock, delay start or cooking time are in the display), recall the remaining time by touching the KITCHEN TIMER ON/OFF pad and then touching the number pads to enter the new time you want.
Consumer Support
To Cancel the Timer
Touch the KITCHEN TIMER ON/OFF pad twice.
Power Outage
If a flashing time is in the display, you have | To reset the clock, touch the CLOCK pad. |
experienced a power failure. Reset the clock. | Enter the correct time of day by touching |
| the appropriate number pads. Touch the |
| START pad. |
16