GE J2B918 installation instructions Install the Anti-Tip Device, When All Hookups Are Completed

Installation of the range.

Install the Anti-Tip Device

An Anti-Tip bracket is supplied with instructions for installation in a variety of locations. The instructions include all necessary information to complete the installation. Read the Safety Instructions and the instructions that fit your situation before beginning installation.

Bracket Wall plate

Screw must enter wood or metal

Typical installation of anti-tip bracket attachment to wall.

WARNING:

■Range must be secured by Anti-Tip bracket supplied.

■If the Anti-Tip device supplied with the range does not fit this application, use the universal Anti-Tip device WB2X7909.

■See instructions to install (supplied with bracket).

■Unless properly installed, the range could be tipped by stepping or sitting on the door. Injury might result from spilled hot liquids or from the range itself.

Consumer Support Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions

When All Hookups Are Completed:

MAKE SURE ALL CONTROLS ARE LEFT IN THE	MAKE SURE THE FLOW OF COMBUSTION
OFF POSITION.	AND VENTILATION AIR TO THE RANGE IS
	UNOBSTRUCTED.

Converting to LP Gas (or converting back to natural gas from LP)

This range leaves the factory set for use with natural gas.	The conversion instructions and LP orifices can
If you want to convert to LP gas, the conversion must be	be found attached to the range next to the
performed by a qualified LP gas installer.	pressure regulator.
	Keep these instructions and the orifices in case
	you want to convert back to natural gas.

52