Amana ARG7800, ARG7600 Gas Connection, Converting Surface Burners for Use with Natural Gas

Page 11

Converting Surface Burners for Use with Natural Gas

1.Remove 4 burner control knobs from range.

•Exposes 2 screws on burner control panel.

2.Remove 2 screws from burner control panel.

•Panel drops slightly after screws are removed.

3.Grasp bottom of burner control panel, gently lift and pull out panel until clear of burner valve stems.

•After burner control panel clears valve stems, continue to roll panel until free from range. Set aside.

•Gas valve and orifice hood are visible after burner control panel are removed.

4.While facing range front, turn orifice hoods clockwise 1½ to 2 turns.

•Use ½ inch, 90° offset crescent wrench.

5.Reassemble burner control panel after adjusting air flow to surface burner flame.

•See Adjusting Surface Burner Flame section.

Converting Oven Burner for Use with

Natural Gas

1.Remove storage drawer.

•Removing Storage Drawer section.

2.Locate and remove 2 screws attaching Z-shaped cover plate.

•Cover plate located in center, rear of storage drawer cavity.

•Removing cover plate exposes oven burner orifice and air shutter.

3.Turn orifice hood counterclockwise 2 full turns.

4.Replace cover plate and storage drawer.

Converting Broiler Burner for Use with

Natural Gas

1.Locate orifice spud attached adjacent to pressure regulator and remove for later use.

•Orifice spud used for natural gas is brass and is stamped “52”.

2.Open oven door and locate broiler burner on oven ceiling.

•Remove oven door to make conversion easier. See Removing Oven Door section.

3.Remove 2 screws securing front of burner to oven ceiling and remove broiler.

•Be careful not to damage ignitor as you remove broiler.

4.Unscrew LP/propane burner spud stamped “58” with 5/16 inch socket wrench and replace with natural gas burner spud stamped “52”.

5.Reinstall broiler and, if necessary, oven door.

Gas Connection

Connect gas supply to regulator using hard pipe or flexible connector (Check local codes). Pressure regulator supplied with this appliance has a ½ inch NPT female connection. If gas union is used, remove storage drawer, slide range into place, and connect union.

•Refer to National Fuel Gas Code or local codes for supply pipe size requirements to assure sufficient gas supply to unit.

•A manual shutoff, not supplied with range, must be installed in an accessible location outside of range.

•Use joint compound that is resistant to action of propane gas on all male pipe threads.

•Use supplied pressure regulator only.

•Do not overtighten gas fitting when attaching to pressure regulator. Overtightening may crack regulator.

•Support pressure regulator with wrench when installing gas fitting.

!WARNING

To avoid property damage or personal injury, only use a new flexible connector that is AGA/CGA design certified.

•Do not use an old connector.

•Do not reuse a connector after moving appliance.

A

B

C

D

A—Regulator

B—Adaptor

C—Flexible Connector

D—Manual Shut Off Valve

Flexible Connection

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Customer Please Read Manual Before Operating Range InstallerContents What to do if YOU Smell GAS Important Safety InformationBroiler Flame Delayed IgnitionSurface Burners Bake Burner FlameInstallation Electrical Connection Requirements Minimum Clearances to Combustible SurfacesSpecial Countertop Conditions Gas Supply Pressure Electrical Connection ClearanceGas Supply Location Gas Connection Requirements Converting for Use with Natural Gas or Propane Gas Pressure Regulator Location Oven Shutoff Valve Converting Surface Burners for Use with LP\Propane Converting Type 2 Pressure Regulator for Use with LP/PropaneConverting Broiler Burner for Use with LP\Propane Converting Oven Burner for Use with LP\PropaneConverting Broiler Burner for Use with Natural Gas Gas ConnectionConverting Surface Burners for Use with Natural Gas Converting Oven Burner for Use with Natural GasPlace Range Testing for Gas LeaksAnti-tip Bracket Installation Seal OpeningsPlace Grates and Burner Caps Removal and Reinstallation of RangeTest and Adjust Surface Burner Flame Removing Oven Bottom Test and Adjust Oven Burner FlameAdjusting Air Shutter Operating Surface Burners Adjust Oven Burner FlameOperation Broiler FlameCooking Utensils Operating Surface Burner during a Power FailureAdjusting Burner Flame Size Pad Description Oven SignalsOven Switches Electronic Oven ControlDisplay Glossary Other FeaturesDisplay Prepare to Bake Setting ClockSetting Minute Timer Baking Delayed BakingAdjusting Oven Temperature To Cancel Remaining Cooking TimeBroiling Prepare for Self-clean Delayed Self-clean CycleBroiling Broiling TipsInterrupt Delayed Self-clean Cycle Self-cleaningInterrupt Self-Clean Cycle Broiling Guide Food Oven Temperature Cooking TimeCooking Guide Baking GuideBeef and Pork Roasting Guide Poultry Roasting GuideRemoving Storage Drawer Care and CleaningRemoving Oven Door Replacing Oven Light Replacing Panel Light Bulb ARG7800Cleaning Part Materials to Use General Directions Problem Check Before Calling for ServiceCooking Products excluding wall ovens WarrantyQuick Reference Instructions Identification du modèle Pièces et accessoiresService après-vente Mise EN Garde Renseignements de sécurité importantsBrûleurs Allumage retardéPrécautions En cas d’incendieOuverture dans le comptoir Mise en serviceEmplacement de la cuisinière Matériaux d’emballageDégagement pour la prise Conditions spéciales concernant le dessus du comptoirAlimentation en électricité Pression de l’alimentation en gaz Emplacement du détendeurEmplacement du raccordement au gaz Alimentation en gazConversion d’un détendeur de type 2 au gaz propane/GPL Soupape d’arrêt du fourConversion au gaz naturel ou au gaz propane Conversion d’un détendeur de type 1 au gaz propane/GPLConversion du brûleur du four au gaz propane/GPL Conversion des brûleurs au gaz propane/GPLConversion des brûleurs au gaz naturel Conversion du brûleur du gril au gaz propane/GPLConversion d’un détendeur de type 1 au gaz naturel Conversion d’un détendeur de type 2 au gaz naturelRaccordement au gaz Obstruction des ouvertures Vérification des fuites de gazPose de la patte de stabilisation Réglage de la flamme des brûleurs Placement des grilles et des couvre-brûleursMise en place de la cuisinière Retrait et remise en place de la cuisinièreRéglage de l’obturateur d’air Réglage de la flamme du fourSurface avoisinante au brûleur Flamme du grilRéglage de l’horloge Retrait de la partie inférieure du fourRéglage de taille de la flamme du brûleur FonctionnementUtilisation des brûleurs de la surface de cuisson Plats de cuissonWok Interrupteurs du four Commandes et interrupteurs du four électroniqueTouche Description Signaux du fourLexique d’affichage AffichageAnnulation de la minuterie Réglage de la minuterieAutres fonctions Comment placer les plats Préparation à la cuissonLa cuisson au four conventionnel Retrait des articles rangés dans le fourPour annuler la durée de cuisson restante Cuisson minutée au four conventionnelCuisson retardée au four conventionnel Cuisson sur le grilCuisson sur le gril Préparation pour l’autonettoyage et l’autonettoyage retardéInterruption du cycle d’autonettoyage AutonettoyageAutonettoyage retardé Aliment Température du four Temps de cuisson Guide de cuissonGuide de cuisson ordinaire Guide de cuisson sur le grilGuide de cuisson du boeuf et du porc Guide de cuisson de la volailleRetrait du tiroir de rangement Remplacement de Lumière du tableau ARG7800Nettoyage et entretien Nettoyage Pièce Produits Indications Problème Vérifier ces points Avant d’appeler le service de dépannageAppareils DE Cuisson Amana sauf les fours encastrés GarantieInstructions de référence rapide
Top Page Image Contents