Aga Ranges U110054 manual Positioning the Range

Page 28

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

Fig.7-1

Min 35½” (90cm) - 36“ (91cm)

For Canada, min 363/8” (92.5cm)

	Min 31½” (80cm)



between the top of the cooktop		Maximum 13”
and a horizontal combustible surface		(33cm)

Minimum 18”

(46cm)

Positioning the Range

Fig.7-1shows the minimum recommended distances and clearances from the range to nearby surfaces.

You MUST provide adequate clearances between the range and adjacent combustible surfaces. These dimensions MUST be met for safe use of your range.

The location of the electrical outlet and pipe opening (see Gas Pipe and Electric Outlet Locations) may be adjusted to meet specific requirements.

	Min 35	15⁄16” (91cm)
	Max 36	7/8” (93.7cm)
			For electrical and

			gas supply zone
	ArtNo.280-0001 36” wide oven dimensions

Min 35½” (90cm) - 36“ (91cm) recommended to allow for moving the range.

For Canada, min 363/8” (92.5cm)

Fig.7-2

44¼” (112.4cm)

28” (71.1cm)

261/8” (66.7cm)

24” (61cm)

	Open oven door
33⁄8” (8.5cm) without	shown dotted
side extension ﬁtted

A gap of at least 3” (7.5 cm) should be left between each side of the range ABOVE the cooktop level and any adjacent vertical surface.

The cooktop surround should be level with, or above, any adjacent work surface.

For non-combustible surfaces (such as unpainted metal or ceramic tiles) the gap each side can be reduced from 3” to 1” (2.5 cm).

A minimum space of 31½” (80cm) is required between the top of the cooktop and a horizontal combustible surface. The maximum depth for cabinets installed above cooktops is 13’’ (33 cm).

The depth of the range is 283/8’’ (72 cm) overall (Fig.7-2).

Any range hood should be installed in accordance with the hood manufacturer’s instructions.

For safety reasons curtains must not be sited immediately behind the range.

We recommend a gap of 35½” (90 cm) – 36” (91 cm (for Canada 363/8” (92.5 cm)) between cupboards to allow for moving the range.

USA only: If a flush fit is required, install the range up to the cupboard at one side then install the cupboard the other side.

26

Image 28

Contents User Guide Contents Important Safety Information Case of FireTo Prevent Fire or Smoke Damage  Do Not Leave Children Alone or UnattendedImportant Safety Notice and Warning Proper InstallationWear Suitable Clothing ConversionPlacement of Oven Racks General Safety InstructionsEnamel and may be cleaned off with a metal polish Use the Right Size PanPage Range Overview Igniting Cooktop Burners without Electricity 5Fig.2-6Wok Burner Multi-function OvenAFig.2-9 Function UseOperating the Oven Multi-function oven modes -13Thaw and Serve Convection OvenSelf-Cleaning Fan Assisted OvenConventional Oven Top and Base Heat Browning ElementEnergy Saving Panel Feature Sabbath ModeRemoving the Divider Clock To set the time of dayTo time something that is cooking minute minder To stop the oven automaticallyAuto is showing, you want to reset to manual cooking Key LockTo activate the key lock To turn off the key lockAccessories Oven racksTo remove and refit the racks To remove and refit the telescopic rack and runnersOven Light StorageTo Remove the Drawer Replace the storage drawerTips on Cooking with the Timer Cooking TipsCooking with a Multi-function Oven General Oven TipsCooking Table MeatTroubleshooting Oven temperature getting hotter as the range gets older Timed oven is not coming on when automatic cookingAn oven light is not working Cleaning Your Range Cleaning for SpillsEssential Information Daily CareSelf-Clean Oven Main TopControl Panel and Oven Doors Removing the oven door outer panelBefore using the self-clean function Self-Clean Operation WARNING! The oven will still be hot Hours SoilingCleaning Table Table Part Finish Recommended Cleaning methodTo cancel the self cleaning cycle To start the self cleaning cycle automatically Warning Installation Installation Safety InstructionsRegulations Converting to Propane GasYou will also need the following tools Additional materials you may needGas line shut-off valve Checking the partsPositioning the Range Moving the Range Removing the Oven DoorRemoving the Storage Drawer  The range is very heavy. Take great careCompleting the Move Installing the Flue GrilleLeveling Kit Contents ProcedureAnti-Tip Device Wall AttachmentElectrical Connection Installing a 3-Wire Power Cord Wire Conduit InstallationDisconnect the supplied power cord from the terminal block Black Gas Connection Gas Supply RequirementsProvide Adequate Gas Supply CanadaConnect the Range to the Gas Supply Flexible Connector CAUTIONleaks. do not use a flame to check for gas Seal the Openings Final FittingCustomer Care Range Operational ChecksMoving the Range for Servicing For Your Safety Valve AdjustmentConversion to Another Gas Conversion to PropaneFor safety’s sake push the drawer rails back out of the way Gas RegulatorReplacing the Bypass Screw TypePressure Testing Stick on labelRefitting the Grille and Drawer Refitting the Flue GrilleCircuit Diagram Code Description Colour CodeTechnical Data DimensionsConnections RatingsPage Page Consumer Warranty If further help is needed concerning this warranty, contactArtNo.000-0003 CE logo