Aga Ranges U110054 manual Seal the Openings, Final Fitting

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

Seal the Openings

Seal any openings in the wall behind the range and in the floor under the range when hookups are completed.

IMPORTANT: When all connections are completed make sure the flow of combustion and ventilation air to the range is unobstructed.

Leveling

Place the range in its intended position taking care not to twist it within the gap between the kitchen units as damage may occur to the range or the units. Install the oven racks in the oven. Check for levelness by placing a level or a cup, partially filled with water, on one of the oven grids. If using a spirit level, take two readings with the level placed diagonally first in one direction and then the other.

The rollers can be adjusted to level the range. To adjust the height of the rear of the range use the leveling tool supplied to turn the adjusting nuts at the front bottom corners of the range.

Final Fitting

Installing the Toe Kick

Remove the 3 screws for the toe kick mounts along the front bottom edge of the range (Fig.7-31). Fasten the toe kick using these screws (alternative color screws can be found in the loose parts pack).

Fitting the Grates

Make sure that the grates are in the correct position and seated properly (Fig.7-32).

Refitting the Storage Drawer

To replace the drawer in the range, pull the side rails fully out (Fig.7-33).

Carefully move the drawer back between the rails and rest it on the side rails (Fig.3-34).

Slide the drawer back onto the side rails so that the clips click into position.

Refitting the Oven Door

To refit the door, slide the hinges back into their slots. Rotate the locking ‘U’ clips back to fit onto the hinges.

Fig.7-31

Fig.7-32

ArtNo.272-0009 - Prof+ pyro - Grate layout

Fig.7-33

Make sure the inner

rail is forwards

Fig.7-34

Drawer

Rail

35