Aga Ranges U110054 manual Igniting Cooktop Burners without Electricity, 5Fig.2-6

Page 8

Fig.2-3

ArtNo.272-0002

Prof+ pyro US - Control to low

LO

HI

OFF

Fig.2-4

ArtNo.311-0001 Rightpans gas

Fig.2-5Fig.2-6

Art No. 311-0003 Simmer aids

Fig.2-7	ArtNo.311-0004 Tipping wok

The igniter should spark and light the gas. Keep holding the knob pressed in to let the gas through to the burner for about ten seconds.

If, when you let go of the control knob, the burner goes out, then the FSD has not been bypassed. Turn the control knob to the OFF position and wait for one minute before you try again, this time making sure to hold in the control knob for slightly longer.

Adjust the flame height to suit by turning the knob. On this range the low position is beyond high, not between high and off. The ‘LO’ marks the low position.

Adjust the flame height to suit by turning the knob counter- clockwise (Fig.2-3).

If a burner flame goes out, turn off the control knob and leave it for one minute before relighting it.

Make sure flames are under the pans (Fig.2-4). For safety reasons, adjust the flames so that they do not extend beyond the edge of the cooking utensil. Using a lid will help the contents boil more quickly.

Large pans should be spaced well apart.

Pans and kettles with concave bases or down turned base rims should not be used (Fig.2-5).

Simmering aids, such as asbestos or mesh mats, are NOT recommended (Fig.2-6). They will reduce burner performance and could damage the grates.

Avoid using unstable or misshapen pans that may tilt easily and pans with a very small base diameter e.g. milk pans, single egg poachers (Fig.2-7).

The minimum pan diameter recommended is 4¾” (12cm) for the outer burners and 6 3/8” (16cm) for the center burner.

Igniting Cooktop Burners without Electricity

If there is a power failure the cooktop burners can be lit with a match.

1.Hold a burning match ½” from the burner head, keeping your hand as far horizontally away from the burner as possible.

2.Push and turn the burner control knob to HI/lighting position. As soon as the burner flame lights move your hand away. With your other hand, keep holding the knob pressed for a few seconds so that the burner safety device can ‘sense’ the heat of the flame.

3.Turn the burner control knob to the OFF position when you have finished using it.

6

Image 8

Contents User Guide Contents Important Safety Information Case of FireTo Prevent Fire or Smoke Damage  Do Not Leave Children Alone or UnattendedImportant Safety Notice and Warning Proper InstallationWear Suitable Clothing ConversionPlacement of Oven Racks General Safety InstructionsEnamel and may be cleaned off with a metal polish Use the Right Size PanPage Range Overview Igniting Cooktop Burners without Electricity 5Fig.2-6Wok Burner Multi-function OvenAFig.2-9 Function UseOperating the Oven Multi-function oven modes -13Thaw and Serve Convection OvenSelf-Cleaning Fan Assisted OvenConventional Oven Top and Base Heat Browning ElementRemoving the Divider Sabbath ModeEnergy Saving Panel Feature Clock To set the time of dayTo time something that is cooking minute minder To stop the oven automaticallyAuto is showing, you want to reset to manual cooking Key LockTo activate the key lock To turn off the key lockAccessories Oven racksTo remove and refit the racks To remove and refit the telescopic rack and runnersOven Light StorageTo Remove the Drawer Replace the storage drawerTips on Cooking with the Timer Cooking TipsCooking with a Multi-function Oven General Oven TipsCooking Table MeatTroubleshooting An oven light is not working Timed oven is not coming on when automatic cookingOven temperature getting hotter as the range gets older Cleaning Your Range Cleaning for SpillsEssential Information Daily CareSelf-Clean Oven Main TopControl Panel and Oven Doors Removing the oven door outer panelBefore using the self-clean function Self-Clean Operation WARNING! The oven will still be hot Hours SoilingCleaning Table Table Part Finish Recommended Cleaning methodTo cancel the self cleaning cycle To start the self cleaning cycle automatically Warning Installation Installation Safety InstructionsRegulations Converting to Propane GasYou will also need the following tools Additional materials you may needGas line shut-off valve Checking the partsPositioning the Range Moving the Range Removing the Oven DoorRemoving the Storage Drawer  The range is very heavy. Take great careLeveling Installing the Flue GrilleCompleting the Move Kit Contents ProcedureAnti-Tip Device Wall AttachmentElectrical Connection Disconnect the supplied power cord from the terminal block Wire Conduit InstallationInstalling a 3-Wire Power Cord Black Gas Connection Gas Supply RequirementsProvide Adequate Gas Supply Canada CAUTIONleaks. do not use a flame to check for gas Flexible ConnectorConnect the Range to the Gas Supply Seal the Openings Final FittingMoving the Range for Servicing Range Operational ChecksCustomer Care For Your Safety Valve AdjustmentConversion to Another Gas Conversion to PropaneFor safety’s sake push the drawer rails back out of the way Gas RegulatorReplacing the Bypass Screw TypePressure Testing Stick on labelRefitting the Grille and Drawer Refitting the Flue GrilleCircuit Diagram Code Description Colour CodeTechnical Data DimensionsConnections RatingsPage Page Consumer Warranty If further help is needed concerning this warranty, contactArtNo.000-0003 CE logo