Aga Ranges U110054 manual Range Operational Checks, Customer Care, Moving the Range for Servicing

Page 38

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

Range Operational Checks

Oven Check

Turn on the oven and check that the oven fans start to turn and that the oven starts to heat up. Turn off the oven.

Oven Light Check

Press the oven light switch and check that the lights are working.

Note: The oven light bulbs are not included in the warranty.

Ignition of the Cooktop Burners Check

Operation of all cooktop burners should be checked after the range and gas supply lines have been carefully checked for leaks.

Check each burner in turn. There is a flame safety device that stops the flow of gas to the burner if the flame goes out. There is also a spark ignition system that works when the knob is pressed in.

For each burner, push in and turn a knob to the lighting position.

The igniter should spark and light the gas. Keep holding the knob pressed in to let the gas through to the burner for few seconds.

If, when you let go of the control knob, the burner goes out, the safety device has not held in. Turn the control to the off position and wait one minute, then try again this time holding in the control knob for slightly longer.

Quality of Flames

If the flame is distorted, check that the burner head is correctly placed over the burner base.

MAKE SURE THE FLOW OF COMBUSTION AND VENTILATION AIR TO THE RANGE IS UNOBSTRUCTED.

MAKE SURE ALL CONTROLS ARE LEFT IN THE OFF POSITION.

Customer Care

Please complete your details in this Guide, inform the user how to operate the range and hand over the Instructions.

Thank you

Moving the Range for Servicing

Follow these procedures to remove appliance for servicing:

Shut off the gas supply and turn off the circuit breaker. Disconnect gas supply tubing to the appliance and unplug the electrical supply cord.

Note: A suitably qualified person should disconnect and reconnect the gas supply.

The range is very heavy, so take great care. We recommend two people maneuver the range. Ensure that the floor covering is firmly attached, or removed to prevent it being disturbed when moving the range around. You will need the leveling tool.

Before attempting to move the range, see ‘Moving the range’ on page 27.

Refitting the Range

Reverse the above procedure to refit. If the gas line has been disconnected, check for gas leaks after reconnection.

Note: A suitably qualified person should disconnect and reconnect the gas supply.

The service engineer MUST follow the installation instructions provided with the gas appliance connector and the warning label attached to the connector.

If the range is removed for any reason, make sure that the anti-tip device is re-engaged properly when the range is replaced. Failure to take this precaution could result in tipping of the range and may cause injury.

36

Image 38
Contents User Guide Contents To Prevent Fire or Smoke Damage Important Safety InformationCase of Fire  Do Not Leave Children Alone or UnattendedWear Suitable Clothing Important Safety Notice and WarningProper Installation ConversionEnamel and may be cleaned off with a metal polish Placement of Oven RacksGeneral Safety Instructions Use the Right Size PanPage Range Overview Igniting Cooktop Burners without Electricity 5Fig.2-6AFig.2-9 Wok BurnerMulti-function Oven Function UseThaw and Serve Operating the OvenMulti-function oven modes -13 Convection OvenConventional Oven Top and Base Heat Self-CleaningFan Assisted Oven Browning ElementRemoving the Divider Sabbath ModeEnergy Saving Panel Feature To time something that is cooking minute minder ClockTo set the time of day To stop the oven automaticallyTo activate the key lock Auto is showing, you want to reset to manual cookingKey Lock To turn off the key lockTo remove and refit the racks AccessoriesOven racks To remove and refit the telescopic rack and runnersTo Remove the Drawer Oven LightStorage Replace the storage drawerCooking with a Multi-function Oven Tips on Cooking with the TimerCooking Tips General Oven TipsCooking Table MeatTroubleshooting An oven light is not working Timed oven is not coming on when automatic cookingOven temperature getting hotter as the range gets older Essential Information Cleaning Your RangeCleaning for Spills Daily CareControl Panel and Oven Doors Self-Clean OvenMain Top Removing the oven door outer panel WARNING! The oven will still be hot Before using the self-clean functionSelf-Clean Operation Hours SoilingTo cancel the self cleaning cycle Cleaning Table TablePart Finish Recommended Cleaning method To start the self cleaning cycle automatically Warning Regulations InstallationInstallation Safety Instructions Converting to Propane GasGas line shut-off valve You will also need the following toolsAdditional materials you may need Checking the partsPositioning the Range Removing the Storage Drawer Moving the RangeRemoving the Oven Door  The range is very heavy. Take great careLeveling Installing the Flue GrilleCompleting the Move Anti-Tip Device Kit ContentsProcedure Wall AttachmentElectrical Connection Disconnect the supplied power cord from the terminal block Wire Conduit InstallationInstalling a 3-Wire Power Cord Black Provide Adequate Gas Supply Gas ConnectionGas Supply Requirements Canada CAUTIONleaks. do not use a flame to check for gas Flexible ConnectorConnect the Range to the Gas Supply Seal the Openings Final FittingMoving the Range for Servicing Range Operational ChecksCustomer Care Conversion to Another Gas For Your SafetyValve Adjustment Conversion to PropaneReplacing the Bypass Screw For safety’s sake push the drawer rails back out of the wayGas Regulator TypePressure Testing Stick on labelRefitting the Grille and Drawer Refitting the Flue GrilleCircuit Diagram Code Description Colour CodeConnections Technical DataDimensions RatingsPage Page Consumer Warranty If further help is needed concerning this warranty, contactArtNo.000-0003 CE logo