Amana ARTC7114*, ARTC7003* owner manual Care and Cleaning, Removing Oven Door, Replacing Oven Light

Page 23
Care and Cleaning

Care and Cleaning

Removing Oven Door

Replacing Oven Light

!CAUTION

To avoid personal injury or property damage, handle oven door with care.

Door is heavy and can be damaged if dropped.

Avoid placing hands in hinge area when door is removed. Hinge can snap closed and pinch hands.

Do not scratch or chip glass, or twist door. Glass may break suddenly.

Replace door glass if damaged.

Do not lift door by handle.

1.Open door fully.

2.Remove screws.

Oven doors are attached with a screw on each side of lower oven door.

3.Close door to first stop, grasp door firmly on each side, and lift upward until door is off hinges.

Do not lift door by handle. Glass can break.

Only push hinges closed once oven door is removed if necessary. Use both hands when closing hinge. Hinge snaps closed.

!WARNING

To avoid risk of burns or electrical shock, disconnect electrical supply to oven before changing light bulb.

Before replacing light bulb make sure bulb is cool.

Do not operate oven without bulb and cover in place.

!CAUTION

Wear gloves to protect hands from accidental bulb breakage.

1.Disconnect electrical supply.

2.Remove oven door if desired.

3.Unscrew light bulb cover located in rear of oven cavity. Then turn light bulb counterclockwise to remove.

4.Replace light bulb with 120-volt, 40-watt appliance bulb.

Do not overtighten bulb or it may be difficult to remove later.

5.Replace light bulb cover and oven door before use.

6.Reconnect power supply.

Removing Oven Door

Removing Storage Drawer

1.

Slide drawer out until it stops.

 

2.

Grasp drawer sides near back of drawer.

Replacing Oven Light Bulb

3.

Lift up and out. Reverse to reinstall.

 

Removing Storage Drawer

23

Image 23
Contents ARTC7114 ARTC7003 Please Read Manual Before Operating Range InstallerCustomer Model Identification Parts and AccessoriesService Asure Extended Service PlanALL RANGES CAN TIP INJURY TO PERSONS COULD RESULT IMPORTANT SAFETY INFORMATIONINSTALL ANTI-TIP BRACKETS PACKED WITH RANGE SEE INSTALLATION INSTRUCTIONSGLASS/CERAMIC COOKING SURFACES SELF-CLEANING OVENSPrecautions SURFACE COOKING UNITSCabinet Opening InstallationPacking Material Range LocationLine Voltage Requirements Power Supply LocationPower Cord Requirements Irregular Cabinet and Countertop HeightsGround strap Installing 3-Wire Power CordNeutral terminal connect wire Power terminalsNumber of wires on each terminal can vary Installing 4-Wire Power CordLevel Range Converting 3-Wire to 4-Wire Power CordAnti-tip Bracket Installation Removal and Replacement of RangeF E D Range FeaturesOperation Introduction cooking is complete, press switch towardsOven Cooking Methods Element and Fan LocationCooking with Surface Elements Surface Element SettingsPreparing to Cook with Smoothtop Elements Temperature Utensil Material CharacteristicCooking Utensils TypePads and Knobs Oven SignalsOven Switches Electronic Oven ControlOther Features Oven Rack Placement Setting Electronic ClockSetting Electronic Timer Resetting and Canceling TimerBaking or Convection Baking CLEANBake Pan Placement Convection Pan PlacementInterrupt Self-Clean Cycle Self-CleaningPrepare for Self-clean Cycle Self-cleaningFood Cooking GuideBaking Guide Poultry Roasting GuideRack position Beef and Pork Roasting GuideBroiling Guide ThicknessConvection Broiling Guide Convection Baking GuideOven temperature Fahrenheit Convection Poultry Roasting GuideConvection Beef and Pork Roasting Guide Removing Storage Drawer Care and CleaningRemoving Oven Door Replacing Oven LightGeneral Directions CleaningPart Materials to UseTo Prevent Cleaning Smoothtop RangetopProblem CauseCheck Before Calling for ServiceLIMITED THIRD THRU FIFTH YEAR WARRANTY ON GLASS/CERAMIC TOP WarrantyCOOKING PRODUCTS excluding wall ovens FULL ONE YEAR WARRANTY LIMITED SECOND YEAR WARRANTY ON ALL PARTSSelf-Cleaning Setting Electronic ClockSetting Electronic Timer Adjusting Factory Set Baking Temperature