Southbend Marathoner manual Stack Double-Deck Oven if necessary

Page 13

MARATHONER GOLD & SILVERSTAR GAS CONVECTION OVENS

INSTALLATION

2.Install eye-bolt (item “F”) to a frame member on the rear of the equipment. After checking carefully behind the frame member for adequate clearance, drill a 1/4" hole through the frame member.

3.Thread hex nut (item “G”) and slide the washer (item “H”) onto the eye-bolt. Insert the eye-bolt through the 1/4" drilled hole and secure with a washer (item “H”) and nylon lock nut (item “I”).

4.Using the spring-loaded snap hooks, attach the restraining device to the bracket and the eye-bolt.

5.Using the cable clamp (item “D”), adjust the restraining device extended length to prevent over-bending or kinking of the appliance connector.

For units not equipped with flame safety devices, be sure all valves are turned off prior to disconnecting. After reconnecting, be sure that the oven is switched OFF.

Step 4: Stack Double-Deck Oven (if necessary)

Double-deck ovens can be shipped already assembled, but can instead be shipped as two single-deck ovens to be stacked in the field. Also, ovens that were originally ordered as single ovens can be stacked in the field (additional parts are required). This installation step describes the procedure for stacking two single-deck ovens to form a double-deck oven.

1.Uncrate the two ovens. Identify the oven that will be the lower oven (it will be the oven with leg pads attached to the bottom corners). Attach the legs (or casters) to the lower oven as described in Step 2c on page 11.

2.If the oven that will be the top oven was NOT ordered as part of a double-deck oven, remove the four leg pads from the bottom of the top oven.

3.Locate and remove the four screws that secure the lower front panel (items “A” in the drawing below). Lift up the panel and pull it forward to remove it, then set it aside.

4.Locate and remove the five screws that secure the right side panel to the oven (items “B” in the drawing below). Remove the right side panel and insulation and set them aside.

 

B

A

 

OPERATOR’S MANUAL 1181887 REV 3

PAGE 13

INSTALLATION

Page 12 Page 14
Image 13
Page 12 Page 14
Contents GAS Convection Ovens Safety Precautions Table of Contents Electricity Supply SpecificationsModel Number # of Ovens Oven Depth Type of Gas Orifice Size GAS SupplySingle-Deck Ovens Exterior DimensionsTOP View Ventilation Minimum ClearancesUnpacking InstallationInstallation of Legs on Single-Deck Ovens Installation of Legs on Double-Deck Ovens Installation of Restraint Only for Ovens with Casters Stack Double-Deck Oven if necessary Operator ’S Manual 1181887 REV Elbow Install the flue stack as shown in the following diagram Install Down Draft Diverter if applicable Installation of Optional Open Rack Storage Operator ’S Manual 1181887 REV Electric Grounding Instructions Connect ElectricityConnect Gas Supply Check the InstallationLIGHTING, RELIGHTING, and Shutdown Instructions OperationOperating the Controls Control Panel of Standard Models Power SwitchOperation of Standard Models Temperature of the ovenTime Display Control Panel of CYCLE/COOK and Hold ModelsOperation of CYCLE/COOK and Hold Models Operation Control Panel of Programmable Models Programs IndicatorsOperation of Models with Programmable Controls Operation Power Switch Time Display Control Panel of Rack Timer ModelsOperation of Rack Timer Models Cooking Hints Time & TemperatureOverloading Helpful SuggestionsGuide to Times and Temperatures Cooking Problems and SolutionsHints Daily Cleaning CleaningMonthly Cleaning Cleaning Stainless Steel Surfaces SEMI-ANNUAL CleaningAdjusting GAS Pressure Regulator AdjustmentsLubrication Adjusting Door Switch Adjusting Door Chain MechanismFahrenheit or Celsius Display Cycle/Cook & Hold Models Only Temperature Controller Standard-Control Models OnlyInterpreting Displayed Error Codes TroubleshootingPerformance Standard Table continues on next Troubleshooting GuideControl Panel Access and SHUT-OFF Switch Troubleshooting GuideBlower Wheel Replacement Troubleshooting Troubleshooting Troubleshooting Troubleshooting Troubleshooting Troubleshooting Parts Index of Parts DiagramsFront Panel and Flue Parts Door Parts Door Chain Mechanism Parts Marathoner Gold & Silverstar GAS Convection Ovens See parts list on previous 1920 Parts See parts list on previous 1918 Parts See parts list on previous Parts Parts Internal Gas Supply Parts Burner Compartment Parts Oven Interior and Fan Motor Parts Oven Light Parts Leg Parts for Single-Deck SilverStar Models Leg Parts for Single-Deck Marathoner Gold Models Storage Rack Parts Double-Deck Oven Stacking Parts Leg Parts for Double-Deck Ovens OPERATOR’S Manual 1181887 REV Marathoner Gold & Silverstar GAS Convection Ovens Marathoner Gold & Silverstar GAS Convection Ovens Marathoner Gold & Silverstar GAS Convection Ovens GAS Convection Ovens

Marathoner specifications

The Southbend Marathoner is an innovative and highly efficient piece of equipment designed for both amateur runners and seasoned athletes alike. This state-of-the-art treadmill combines advanced technology with a focus on performance, comfort, and durability, making it a popular choice for fitness enthusiasts. The Southbend Marathoner features an impressive motor that delivers a smooth, consistent performance, allowing users to reach their desired speed without interruption. With a peak horsepower that rivals that of commercial-grade treadmills, it is well-suited for rigorous training sessions.

One of the standout features of the Southbend Marathoner is its advanced cushioning system. This technology significantly reduces impact on joints, promoting a more comfortable running experience and minimizing the risk of injury. The cushioned running surface is designed to replicate outdoor conditions, providing an authentic feel that simulates the experience of running on natural terrain.

The treadmill comes equipped with a large, user-friendly display that provides essential metrics including speed, distance, time, calories burned, and heart rate. This data is crucial for runners looking to monitor their progress and set new personal records. Furthermore, the Southbend Marathoner includes Bluetooth connectivity, allowing users to sync their fitness trackers and access detailed performance analytics through compatible apps.

Another notable characteristic is the treadmill's incline feature, which can be adjusted electronically to replicate hill running. This added level of intensity allows users to diversify their workouts and enhance their endurance over time. With a maximum incline of 15%, runners can simulate challenging terrains, improving strength and stamina.

In addition to its impressive performance features, the Southbend Marathoner boasts a sleek and modern design. The treadmill is built with high-quality materials that ensure longevity and stability during use. Its foldable design offers practical storage solutions for smaller spaces, making it a versatile option for home gyms.

In summary, the Southbend Marathoner stands out as a premier treadmill that caters to the needs of runners at every skill level. With its powerful motor, advanced cushioning system, user-friendly display, connectivity options, and adjustable incline settings, it provides a comprehensive and enjoyable running experience. It's more than just a treadmill; it's an investment in fitness that supports and motivates users to achieve their running goals.
Top Page Image Contents