Southbend Marathoner manual Temperature Controller Standard-Control Models Only

Page 40

ADJUSTMENTS

MARATHONER GOLD & SILVERSTAR GAS CONVECTION OVENS

TEMPERATURE CONTROLLER (Standard-Control Models Only)

The calibration of the temperature controller should not be changed until sufficient experience with cooking results has definitely proved that the temperature controller is not maintaining proper oven temperatures. Before any recalibration is attempted, the oven temperature should be checked by the following procedure:

1.Remove all trays and pans from the oven.

2.Place a thermocouple or a reliable mercury oven-type thermometer at the center of the middle rack.

3.Turn the oven ON and set the temperature control knob to 400°F.

4.The amber “heat on” light will go out when the oven temperature is reached.

5.Allow three cycles for the temperature to stabilize.

6.Read the thermocouple or thermometer immediately after the light goes out for the third time, and again immediately after it comes on the next time.

7.If the average of these readings varies by more than 10°F from the dial setting, recalibrate by the following procedure. Recalibration should be attempted only by a competent service technician.

Use the following procedure to recalibrate the oven:

1.Loosen the two set screws that secure the temperature-control knob to the temperature-control shaft.

2.Remove the knob from the shaft, being careful not to rotate the knob or shaft.

3.Replace the knob on the shaft so that the indicator mark on the knob points directly at the temperature that was measured at the center of the oven.

4.Re-check the oven calibration.

FAHRENHEIT OR CELSIUS DISPLAY (Cycle/Cook & Hold Models Only)

Ovens with Cycle/Cook & Hold controls can be configured to display temperatures using the Fahrenheit or the Celsius scales. To change the choice, change the position of the blue jumper “J3” on the rear of the control panel circuit board.

ADJUSTMENTS

PAGE 40

OPERATORS MANUAL 1181887 REV 3

Image 40
Contents GAS Convection Ovens Safety Precautions Table of Contents Specifications Electricity SupplyGAS Supply Model Number # of Ovens Oven Depth Type of Gas Orifice SizeExterior Dimensions Single-Deck OvensTOP View Minimum Clearances VentilationInstallation UnpackingInstallation of Legs on Single-Deck Ovens Installation of Legs on Double-Deck Ovens Installation of Restraint Only for Ovens with Casters Stack Double-Deck Oven if necessary Operator ’S Manual 1181887 REV Elbow Install the flue stack as shown in the following diagram Install Down Draft Diverter if applicable Installation of Optional Open Rack Storage Operator ’S Manual 1181887 REV Connect Electricity Electric Grounding InstructionsCheck the Installation Connect Gas SupplyLIGHTING, RELIGHTING, and Shutdown Instructions OperationOperating the Controls Power Switch Control Panel of Standard ModelsTemperature of the oven Operation of Standard ModelsControl Panel of CYCLE/COOK and Hold Models Time DisplayOperation of CYCLE/COOK and Hold Models Operation Programs Indicators Control Panel of Programmable ModelsOperation of Models with Programmable Controls Operation Control Panel of Rack Timer Models Power Switch Time DisplayOperation of Rack Timer Models Time & Temperature Cooking HintsOverloading Helpful SuggestionsCooking Problems and Solutions Guide to Times and TemperaturesHints Daily Cleaning CleaningMonthly Cleaning SEMI-ANNUAL Cleaning Cleaning Stainless Steel SurfacesAdjusting GAS Pressure Regulator AdjustmentsLubrication Adjusting Door Chain Mechanism Adjusting Door SwitchTemperature Controller Standard-Control Models Only Fahrenheit or Celsius Display Cycle/Cook & Hold Models OnlyInterpreting Displayed Error Codes TroubleshootingPerformance Standard Troubleshooting Guide Table continues on nextTroubleshooting Guide Control Panel Access and SHUT-OFF SwitchBlower Wheel Replacement Troubleshooting Troubleshooting Troubleshooting Troubleshooting Troubleshooting Troubleshooting Index of Parts Diagrams PartsFront Panel and Flue Parts Door Parts Door Chain Mechanism Parts Marathoner Gold & Silverstar GAS Convection Ovens See parts list on previous 1920 Parts See parts list on previous 1918 Parts See parts list on previous Parts Parts Internal Gas Supply Parts Burner Compartment Parts Oven Interior and Fan Motor Parts Oven Light Parts Leg Parts for Single-Deck SilverStar Models Leg Parts for Single-Deck Marathoner Gold Models Storage Rack Parts Double-Deck Oven Stacking Parts Leg Parts for Double-Deck Ovens OPERATOR’S Manual 1181887 REV Marathoner Gold & Silverstar GAS Convection Ovens Marathoner Gold & Silverstar GAS Convection Ovens Marathoner Gold & Silverstar GAS Convection Ovens GAS Convection Ovens

Marathoner specifications

The Southbend Marathoner is an innovative and highly efficient piece of equipment designed for both amateur runners and seasoned athletes alike. This state-of-the-art treadmill combines advanced technology with a focus on performance, comfort, and durability, making it a popular choice for fitness enthusiasts. The Southbend Marathoner features an impressive motor that delivers a smooth, consistent performance, allowing users to reach their desired speed without interruption. With a peak horsepower that rivals that of commercial-grade treadmills, it is well-suited for rigorous training sessions.

One of the standout features of the Southbend Marathoner is its advanced cushioning system. This technology significantly reduces impact on joints, promoting a more comfortable running experience and minimizing the risk of injury. The cushioned running surface is designed to replicate outdoor conditions, providing an authentic feel that simulates the experience of running on natural terrain.

The treadmill comes equipped with a large, user-friendly display that provides essential metrics including speed, distance, time, calories burned, and heart rate. This data is crucial for runners looking to monitor their progress and set new personal records. Furthermore, the Southbend Marathoner includes Bluetooth connectivity, allowing users to sync their fitness trackers and access detailed performance analytics through compatible apps.

Another notable characteristic is the treadmill's incline feature, which can be adjusted electronically to replicate hill running. This added level of intensity allows users to diversify their workouts and enhance their endurance over time. With a maximum incline of 15%, runners can simulate challenging terrains, improving strength and stamina.

In addition to its impressive performance features, the Southbend Marathoner boasts a sleek and modern design. The treadmill is built with high-quality materials that ensure longevity and stability during use. Its foldable design offers practical storage solutions for smaller spaces, making it a versatile option for home gyms.

In summary, the Southbend Marathoner stands out as a premier treadmill that caters to the needs of runners at every skill level. With its powerful motor, advanced cushioning system, user-friendly display, connectivity options, and adjustable incline settings, it provides a comprehensive and enjoyable running experience. It's more than just a treadmill; it's an investment in fitness that supports and motivates users to achieve their running goals.