Southbend Marathoner Troubleshooting, Performance Standard, Interpreting Displayed Error Codes

Page 41

MARATHONER GOLD & SILVERSTAR GAS CONVECTION OVENS TROUBLESHOOTING

TROUBLESHOOTING

!WARNING

ADJUSTMENTS AND SERVICE WORK MAY BE PERFORMED ONLY BY A QUALIFIED TECHNICIAN WHO IS EXPERIENCED IN, AND KNOWLEDGEABLE WITH, THE OPERATION OF COMMERCIAL COOKING EQUIPMENT. HOWEVER, TO ASSURE YOUR CONFIDENCE, CONTACT YOUR AUTHORIZED SERVICE AGENCY FOR RELIABLE SERVICE, DEPENDABLE ADVICE OR OTHER ASSISTANCE, AND FOR GENUINE FACTORY PARTS.

NOTICE

Warranty will be void and the manufacturer is relieved of all liability if service work is performed by other than a qualified technician, or if other than genuine Southbend replacement parts are installed.

In case of problems in operation at initial installation, check type of gas and manifold pressure and compare with information listed on the serial plate. The serial plate is located inside the lower front panel.

PERFORMANCE STANDARD

The typical time for the oven to heat from 75°F to 350°F is 5 to 6 minutes for ovens using natural gas, and 7 to 8 minutes for ovens using propane.

The burners should come on when the actual oven temperature drops to 10°F below the temperature setting.

INTERPRETING DISPLAYED ERROR CODES

Programmable and Rack Timer models are able to detect some problems that might occur. If the control panel display is showing a letter “F” followed by a number, consult the following table to determine the problem and appropriate corrective action.

Symptom

Possible Cause

Check or Replace

Display shows F1

Bad temperature controller.

Display shows F2

Oven interior maximum temperature

 

exceeded.

Display shows F3

Open temperature probe.

 

 

Display shows F4

Shorted temperature probe.

 

 

Display shows F5

Bad temperature controller.

 

 

Display shows F6

Bad temperature controller.

 

 

Display shows F7

Total cook time in a program exceeds 24

 

hours (programmable models only).

Display shows F8

Bad temperature controller.

Replace temperature controller.

Check whether gas valve is stuck open. If not, replace temperature controller.

Check connection. If connection is OK, replace probe. Check probe wires. If wires are not shorted, replace probe. Replace temperature controller.

Replace temperature controller.

Change program so that total cook time does not exceed 24 hours.

Replace temperature controller.

TROUBLESHOOTING

OPERATORS MANUAL 1181887 REV 3

PAGE 41

Image 41
Contents GAS Convection Ovens Safety Precautions Table of Contents Electricity Supply SpecificationsModel Number # of Ovens Oven Depth Type of Gas Orifice Size GAS SupplySingle-Deck Ovens Exterior DimensionsTOP View Ventilation Minimum ClearancesUnpacking InstallationInstallation of Legs on Single-Deck Ovens Installation of Legs on Double-Deck Ovens Installation of Restraint Only for Ovens with Casters Stack Double-Deck Oven if necessary Operator ’S Manual 1181887 REV Elbow Install the flue stack as shown in the following diagram Install Down Draft Diverter if applicable Installation of Optional Open Rack Storage Operator ’S Manual 1181887 REV Electric Grounding Instructions Connect ElectricityConnect Gas Supply Check the InstallationOperating the Controls OperationLIGHTING, RELIGHTING, and Shutdown Instructions Control Panel of Standard Models Power SwitchOperation of Standard Models Temperature of the ovenTime Display Control Panel of CYCLE/COOK and Hold ModelsOperation of CYCLE/COOK and Hold Models Operation Control Panel of Programmable Models Programs IndicatorsOperation of Models with Programmable Controls Operation Power Switch Time Display Control Panel of Rack Timer ModelsOperation of Rack Timer Models Cooking Hints Time & TemperatureOverloading Helpful SuggestionsGuide to Times and Temperatures Cooking Problems and SolutionsHints Monthly Cleaning CleaningDaily Cleaning Cleaning Stainless Steel Surfaces SEMI-ANNUAL CleaningLubrication AdjustmentsAdjusting GAS Pressure Regulator Adjusting Door Switch Adjusting Door Chain MechanismFahrenheit or Celsius Display Cycle/Cook & Hold Models Only Temperature Controller Standard-Control Models OnlyPerformance Standard TroubleshootingInterpreting Displayed Error Codes Table continues on next Troubleshooting GuideControl Panel Access and SHUT-OFF Switch Troubleshooting GuideBlower Wheel Replacement Troubleshooting Troubleshooting Troubleshooting Troubleshooting Troubleshooting Troubleshooting Parts Index of Parts DiagramsFront Panel and Flue Parts Door Parts Door Chain Mechanism Parts Marathoner Gold & Silverstar GAS Convection Ovens See parts list on previous 1920 Parts See parts list on previous 1918 Parts See parts list on previous Parts Parts Internal Gas Supply Parts Burner Compartment Parts Oven Interior and Fan Motor Parts Oven Light Parts Leg Parts for Single-Deck SilverStar Models Leg Parts for Single-Deck Marathoner Gold Models Storage Rack Parts Double-Deck Oven Stacking Parts Leg Parts for Double-Deck Ovens OPERATOR’S Manual 1181887 REV Marathoner Gold & Silverstar GAS Convection Ovens Marathoner Gold & Silverstar GAS Convection Ovens Marathoner Gold & Silverstar GAS Convection Ovens GAS Convection Ovens

Marathoner specifications

The Southbend Marathoner is an innovative and highly efficient piece of equipment designed for both amateur runners and seasoned athletes alike. This state-of-the-art treadmill combines advanced technology with a focus on performance, comfort, and durability, making it a popular choice for fitness enthusiasts. The Southbend Marathoner features an impressive motor that delivers a smooth, consistent performance, allowing users to reach their desired speed without interruption. With a peak horsepower that rivals that of commercial-grade treadmills, it is well-suited for rigorous training sessions.

One of the standout features of the Southbend Marathoner is its advanced cushioning system. This technology significantly reduces impact on joints, promoting a more comfortable running experience and minimizing the risk of injury. The cushioned running surface is designed to replicate outdoor conditions, providing an authentic feel that simulates the experience of running on natural terrain.

The treadmill comes equipped with a large, user-friendly display that provides essential metrics including speed, distance, time, calories burned, and heart rate. This data is crucial for runners looking to monitor their progress and set new personal records. Furthermore, the Southbend Marathoner includes Bluetooth connectivity, allowing users to sync their fitness trackers and access detailed performance analytics through compatible apps.

Another notable characteristic is the treadmill's incline feature, which can be adjusted electronically to replicate hill running. This added level of intensity allows users to diversify their workouts and enhance their endurance over time. With a maximum incline of 15%, runners can simulate challenging terrains, improving strength and stamina.

In addition to its impressive performance features, the Southbend Marathoner boasts a sleek and modern design. The treadmill is built with high-quality materials that ensure longevity and stability during use. Its foldable design offers practical storage solutions for smaller spaces, making it a versatile option for home gyms.

In summary, the Southbend Marathoner stands out as a premier treadmill that caters to the needs of runners at every skill level. With its powerful motor, advanced cushioning system, user-friendly display, connectivity options, and adjustable incline settings, it provides a comprehensive and enjoyable running experience. It's more than just a treadmill; it's an investment in fitness that supports and motivates users to achieve their running goals.