Southbend Marathoner manual Connect Gas Supply, Check the Installation

Page 21

MARATHONER GOLD & SILVERSTAR GAS CONVECTION OVENS

INSTALLATION

Step 8: Connect Gas Supply

NOTICE

The installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1, Natural Gas Installation Code, CAN/CGA-B149.1,or the Propane Installation Code CAN/CGA-B149.2,as applicable, including:

1.The appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 psi (3.45 kPa).

2.The appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.45 kPa).

A 3/4" NPT line is provided at the rear for the gas connection.

If this equipment is being installed at over 2,000 feet altitude and that information was not specified when ordered, contact the appropriate authorized Southbend Service Representative or the Southbend Service Department. Failure to install with proper orifice sizing will result in poor performance and may void the warranty.

The serial plate is located inside the front lower panel. It indicates the type of gas the unit is equipped to burn. All Southbend equipment is adjusted at the factory. Check type of gas on serial plate.

These models are design-certified for operation on natural or propane gases. For natural gas, the regulator is set to deliver a 4.5" W.C. pressure to the manifold. For propane gas, it is set to deliver 11" W.C.

This appliance should be connected ONLY to the type of gas for which it is equipped. The inlet pressure before the regulator should be 7-10" W.C. for natural gas or 11-14" W.C. for LP gas.

An adequate gas supply is imperative. Undersized or low pressure lines will restrict the volume of gas required for satisfactory performance. Fluctuations of more than 25% on natural gas or 10% on propane gas will create problems and affect burner operating characteristics.

An adequate gas supply line to the unit should be no smaller than the I.D. of the pipe from the unit to which it is connected.

Purge the supply line to clean out dust, dirt, or other foreign matter before connecting the line to the unit.

!CAUTION

ALL PIPE JOINTS AND CONNECTIONS MUST BE TESTED THOROUGHLY FOR GAS LEAKS. USE ONLY SOAPY WATER FOR TESTING ON ALL GASES. NEVER USE AN OPEN FLAME TO CHECK FOR GAS LEAKS. ALL CONNECTIONS MUST BE CHECKED FOR LEAKS AFTER THE UNIT HAS BEEN PUT INTO OPERATION. TEST PRESSURE SHOULD NOT EXCEED 1/4" W.C.

Step 9: Check the Installation

1.Check that all screws and bolts are tightened.

2.Move the oven into the position at which it will be operated.

3.Check that the oven is level. If not, adjust the legs.

4.Check that the appropriate clearances are satisfied (see page 8).

INSTALLATION

OPERATOR’S MANUAL 1181887 REV 3

PAGE 21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents GAS Convection Ovens Safety Precautions Table of Contents Electricity Supply SpecificationsModel Number # of Ovens Oven Depth Type of Gas Orifice Size GAS SupplySingle-Deck Ovens Exterior DimensionsTOP View Ventilation Minimum ClearancesUnpacking InstallationInstallation of Legs on Single-Deck Ovens Installation of Legs on Double-Deck Ovens Installation of Restraint Only for Ovens with Casters Stack Double-Deck Oven if necessary Operator ’S Manual 1181887 REV Elbow Install the flue stack as shown in the following diagram Install Down Draft Diverter if applicable Installation of Optional Open Rack Storage Operator ’S Manual 1181887 REV Electric Grounding Instructions Connect ElectricityConnect Gas Supply Check the InstallationOperation LIGHTING, RELIGHTING, and Shutdown InstructionsOperating the Controls Control Panel of Standard Models Power SwitchOperation of Standard Models Temperature of the ovenTime Display Control Panel of CYCLE/COOK and Hold ModelsOperation of CYCLE/COOK and Hold Models Operation Control Panel of Programmable Models Programs IndicatorsOperation of Models with Programmable Controls Operation Power Switch Time Display Control Panel of Rack Timer ModelsOperation of Rack Timer Models Cooking Hints Time & TemperatureOverloading Helpful SuggestionsGuide to Times and Temperatures Cooking Problems and SolutionsHints Cleaning Daily CleaningMonthly Cleaning Cleaning Stainless Steel Surfaces SEMI-ANNUAL CleaningAdjustments Adjusting GAS Pressure RegulatorLubrication Adjusting Door Switch Adjusting Door Chain MechanismFahrenheit or Celsius Display Cycle/Cook & Hold Models Only Temperature Controller Standard-Control Models OnlyTroubleshooting Interpreting Displayed Error CodesPerformance Standard Table continues on next Troubleshooting GuideControl Panel Access and SHUT-OFF Switch Troubleshooting GuideBlower Wheel Replacement Troubleshooting Troubleshooting Troubleshooting Troubleshooting Troubleshooting Troubleshooting Parts Index of Parts DiagramsFront Panel and Flue Parts Door Parts Door Chain Mechanism Parts Marathoner Gold & Silverstar GAS Convection Ovens See parts list on previous 1920 Parts See parts list on previous 1918 Parts See parts list on previous Parts Parts Internal Gas Supply Parts Burner Compartment Parts Oven Interior and Fan Motor Parts Oven Light Parts Leg Parts for Single-Deck SilverStar Models Leg Parts for Single-Deck Marathoner Gold Models Storage Rack Parts Double-Deck Oven Stacking Parts Leg Parts for Double-Deck Ovens OPERATOR’S Manual 1181887 REV Marathoner Gold & Silverstar GAS Convection Ovens Marathoner Gold & Silverstar GAS Convection Ovens Marathoner Gold & Silverstar GAS Convection Ovens GAS Convection Ovens

Marathoner specifications

The Southbend Marathoner is an innovative and highly efficient piece of equipment designed for both amateur runners and seasoned athletes alike. This state-of-the-art treadmill combines advanced technology with a focus on performance, comfort, and durability, making it a popular choice for fitness enthusiasts. The Southbend Marathoner features an impressive motor that delivers a smooth, consistent performance, allowing users to reach their desired speed without interruption. With a peak horsepower that rivals that of commercial-grade treadmills, it is well-suited for rigorous training sessions.

One of the standout features of the Southbend Marathoner is its advanced cushioning system. This technology significantly reduces impact on joints, promoting a more comfortable running experience and minimizing the risk of injury. The cushioned running surface is designed to replicate outdoor conditions, providing an authentic feel that simulates the experience of running on natural terrain.

The treadmill comes equipped with a large, user-friendly display that provides essential metrics including speed, distance, time, calories burned, and heart rate. This data is crucial for runners looking to monitor their progress and set new personal records. Furthermore, the Southbend Marathoner includes Bluetooth connectivity, allowing users to sync their fitness trackers and access detailed performance analytics through compatible apps.

Another notable characteristic is the treadmill's incline feature, which can be adjusted electronically to replicate hill running. This added level of intensity allows users to diversify their workouts and enhance their endurance over time. With a maximum incline of 15%, runners can simulate challenging terrains, improving strength and stamina.

In addition to its impressive performance features, the Southbend Marathoner boasts a sleek and modern design. The treadmill is built with high-quality materials that ensure longevity and stability during use. Its foldable design offers practical storage solutions for smaller spaces, making it a versatile option for home gyms.

In summary, the Southbend Marathoner stands out as a premier treadmill that caters to the needs of runners at every skill level. With its powerful motor, advanced cushioning system, user-friendly display, connectivity options, and adjustable incline settings, it provides a comprehensive and enjoyable running experience. It's more than just a treadmill; it's an investment in fitness that supports and motivates users to achieve their running goals.
Top Page Image Contents