Multiquip MQ62TDD Trailer Safety Guidelines, Trailer Safety Information, TrailerTowing Guidelines

TRAILER SAFETY GUIDELINES

TRAILER SAFETY INFORMATION

Safety precautions should be followed at all times when operating this equipment. Failure to read, understand and follow the Operating Instructions could result in injury to yourself and others.Loss of control of the trailer or tow vehicle can result in death or serious injury.

Common Causes for Loss of Trailer

■Driving too fast for the conditions (maximum speed when towing a trailer is 60 m.p.h.).

■Overloading the trailer or loading the trailer unevenly

■Trailer improperly coupled to the hitch

■No braking on trailer

■Not maintaining proper tire pressure

■Not keeping lug nuts tight

■Not properly maintaining the trailer structure.

TrailerTowing Guidelines

■Recheck the load tiedowns to make sure the load will not shift during towing.

■Before towing, check coupling, safety chain, safety brake, tires, wheels and lights.

■Check the lug nuts or bolts for tightness.

■Check coupler tightness after towing 50 miles.

■Adjust the brake controller to engage the trailer brakes before the tow vehicle brakes. Your dealer can assist you by making this adjustment.

■Use your mirrors to verify that you have room to change lanes or pull into traffic.

■Use your turn signals well in advance. Allow plenty of stopping space for your trailer and tow vehicle.

■Allow plenty of stopping space for your trailer and tow vehicle.

■DO NOT drive so fast that the trailer begins to sway due to speed.

■Allow plenty of room for passing. A rule of thumb is that the passing distance with a trailer is 4 times the passing distance without the trailer.

■Shiftyourautomatictransmissionintoalowergearforcitydriving.

■ALWAYS use lower gears for climbing and descending grades.

■DO NOT ride the brakes while descending grades, they may get so hot that they stop working. Then you will potentially have a runaway tow vehicle and trailer.

■To conserve fuel, don’t use full throttle to climb a hill. instead, build speed on the approach.

■Slow down for bumps in the road. Take your foot off the brake when crossing the bump.

■DO NOT brake while in a curve unless absolutely necessary. Instead, slow down before you enter the curve and power through the curve. This way, the towing vehicle remains in charge.

■DO NOT apply the brakes to correct extreme trailer swaying. Continued pulling of the trailer, and even slight acceleration, will provide a stabilizing force.

■Anticipate the trailer“swaying.” Swaying is the trailer reaction to the air pressure wave caused by passing trucks and busses. Continued pulling of the trailer provides a stabilizing force to correct swaying. DO NOTapply the brakes to correct trailer swaying.

■Use lower gear when driving down steep or long grades. Use the engine and transmission as a brake. Do not ride the brakes, as they can overheat and become ineffective.

■Be aware of your trailer height, especially when approaching roofed areas and around trees.

■Make regular stops, about once each hour. Confirm that: A. Coupler is secure to the hitch and is locked.

B. Electrical connectors are made.

C. There is appropriate slack in the safety chains.

D.There is appropriate slack in the breakaway switch pullpin cable.

E.Tires are not visibly low on pressure

WARNING — Drive Safely

Driving too fast for severe road conditions can result in loss of control and cause death or serious injury.

Decrease your speed as road, weather and lighting conditions deteriorate.

ALWAYS check for local trailer-tow speed limits in your area.

MQ62TDD TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #0 (07/30/09) — PAGE 33