Alpine PXI-H990 owner manual 90-EN, Mode

Using the multi-channel function

Supplementary information

This page includes supplementary information for pages 52 to 87. Please refer to these pages.

TITLE	Description	Related page
6.1-Channel	The operations performed with the remote control unit in
Settings (6.1CH	step 1 can also be performed by pressing and holding	Page 77
MODE)	MENU (SETUP) for at least 3 seconds, moving the joystick
	up or down to select “AP SETUP”, then pressing the joystick.
	When the speaker is set to “OFF” mode, audio is not
	produced from that speaker. See “Setting the speakers”,	Page 77
	(page 7) and “Speaker setup”, (page 53).
	Once the settings are made, we recommend storing them in	Page 77
	the memory. See page 93 for instructions.
PCM Output	The operations performed with the remote control unit in
Settings (PCM OUT	step 1 can also be performed by pressing and holding	Page 80
MODE)	MENU (SETUP) for at least 3 seconds, moving the joystick
	up or down to select “AP SETUP”, then pressing the joystick.
	When a speaker is set to the “OFF” mode, no sound is
	output from that speaker. See “Setting the speakers” (page	Page 80
	7).
	The “DOLBY PROLOGIC II” and “DTS Neo:6” settings are
	only valid for 2-channel audio signals (including PCM and	Page 80
	bit stream).
	Once the settings are made, we recommend storing them in	Page 80
	the memory. See page 93 for instructions.
	When playing back 96kHz or 192kHz DVD-Audio when
	DOLBY PRO LOGIC II or DTS Neo:6 mode is selected, the	Page 82
	audio signal is automatically down sampled to 48 kHz and
	played back.
	When “PL II MUSIC” is selected
	This adjustment, there is no effect from CENTER WIDTH. If	Page 83
	the center speaker is set to “OFF” in the speaker setup
	settings.
	“BI PHANTOM” is turned off when “CENTER WIDTH” is	Page 83
	enabled.

90-EN