Middleby Cooking Systems Group PS536 manual Stacking, Restraint Cable Installation

SECTION 2 - INSTALLATION

B.Stacking

		For single ovens, skip ahead to Part C, Restraint Cable
		Installation. For double or triple ovens, continue on to Step
		1, below.
ENGLISH	1.	Assemble the stacking spacer(s) as shown in Figure 2-5.
		One spacer assembly is supplied for a double oven, while
		two are supplied for a triple oven.
	2.	Place one of the assembled spacers on top of the lower
		oven cavity, making sure that the insulation faces up.
	3.	Place the center oven cavity (for triple ovens) or the top oven
		cavity (for double ovens) on top of the spacer. Check that
		all four sides of the spacer overlap the base of the oven, and
		that the oven is level and firmly seated. See Figure 2-6.
	4.	For triple ovens, repeat Steps 2 and 3 to install the top oven
		cavity.

Figure 2-6 - Stacking

Assembled

spacer

(insulation faces up)

Figure 2-5 - Assembling the stacking spacers

#10-32 x 1/2"

hex screws

1-1/2" (38mm)-thick insulation, pre-cut

Stacking panel,

P/N 44837

Top panel,

P/N 42882

C.Restraint Cable Installation

Because the oven is equipped with casters, a restraint cable assembly must be installed to limit the movement of the appliance without depending on the connector and the quick disconnect device or its associated piping. One end of the cable is anchored to the eyebolt on one of the rear leg extensions, while the other is anchored to the wall. See Figure 2-7.

After connecting the restraint cable, move the oven to its final location. Then, lock the two front casters.

Figure 2-7 - Installing the Restraint Cable

3/8"-16 x 1" eyebolt on rear leg extension

Restraint cable

assembly

3/4” (19mm)

eyebolt

Wall of

structure

10