ENGLISH
SECTION 2 - INSTALLATION
5.If it is necessary to add or remove conveyor links to achieve the correct tension, OR if it is necessary to reverse the conveyor belt for correct orientation, the belt will need to be removed from the conveyor frame. If this is necessary, perform the following procedure:
•Remove the conveyor assembly from the oven and place it flat on the floor.
•Remove the master links using
•Add or remove belt links as necessary to achieve the correct belt tension.
•Replace the belt on the conveyor frame. Check that the conveyor belt links are oriented as shown in Figure 2- 12, and that the smooth side of the conveyor belt faces UP.
•Connect the inside master links. Check that the links are oriented as shown in Figure
•Connect the outside master links. Note that the outside master links each have an open hook on one side. This hook aligns with the hooks along the sides of the other conveyor links. See Figure
•Replace the conveyor into the oven.
E.Final Assembly
6.Install the drive chain between the conveyor drive sprocket and the motor sprocket. To install the chain, it will be necessary to lift the drive end of the conveyor slightly.
7.Install the conveyor chain cover as shown in Figure
8.Install the crumb trays as shown in Figure
9.Press the end stop down over the edge of the conveyor frame at the exit end of the oven, as shown in Figure
Figure 2-12 - Conveyor and master link orientation
Direction | CORRECT | |
of travel | ||
master link | ||
| ||
| position |
Incorrect
master link
position
Figure 2-13 - Final assembly
Press conveyor end stop
down over edge of
conveyor frame
Hang chain cover on
screws in control compartment wall
Place inside edge of tray on retainer bracket
Swing outside
edge of tray up
and into place
12