Kenmore Kitchen Grill manual Steak Grill no, To Install, To Clean Steak Grill

Page 8

cooking on top o

STEAK GRILL NO. 49924

INSTALLING AND REMOVING

PLUGJN STEAK GRILL

The steak grill module can be used on either side or you can use two steak grills,,

NOTE

The plug-in heating element is used when cooking with the grill, Separate front and rear heating units are controlled by setting one or both surface unit controls_

CAUTION

Be sure the switch is turned OFF and the module is coo! before removing.

NOTE: To eliminate smoke during grilling, a range vent hood must be used (See Page 10),

Grill

Grates

Heating

Etement

Grease

Shield

Module

Pan

TO INSTALL

1_ Place module pan into the empty wetl with the opening towards the terminat block (See Step 1).

2.Next, place the grease shield inside the module pan (See Step 2).

3o Grasp the heating element with both hands and ptug into receptacle (See Step 3), Lower into

place Make sure cross member supports of heating element rest on ledges of module pan

4, Place the two grill grates on top (See Step 4)

TO REMOVE

1. Lift the grill grates off the top (See Step 4)

2, Grasp the heating element with both hands, Jifting slightly Pull toward you to unplug the heating ele- ment (See Step 3)

3.Lift grease shield from module pan (See Step 2)

4o Lift module pan out of the cooktop Remove as directed to avoid spills of fat drippings Clean all parts after each use

TO CLEAN STEAK GRILL

DO NOT PUT GRILL COMPONENTS IN THE OVEN FOR SELF-CLEAN. COMPONENTS WiLL DISTORT AT THE

HIGH TEMPERATURE Wash the module pan and grease shield in warm, soapy water with a plastic scour-

e

Step1

Step

Step 3

Step 4

ing pad Clean after each use Wash grill grates in warm, soapy water For tough spots use a mild abrasive cleaner Be careful not to damage

STEAK GRILL HINTS AND TIPS

1o Cooking on the grill can produce spattering, It is important to c_ean a_l parts after each use If not cleaned, fat drippings can become rancid

2.The heating element for the grill, tike the surface units, cleans itself It must not be immersed in water

3.Take grill apart to clean and to remove and store 4, To help eliminate smoke during grilling, a hood is

recommended

5, Most utensils which are safe for use on an out-door grill may be used with your Grill Module

NOTE: Some f]are.ups may occur while you are cooking Flare-ups are caused by the iuices hitting the heating element Flare-ups and resulting smoke give foods their deliciOUS flavor and appearance Should excess flaring occur, remove food from grilt and turn Control Knob to OFF Never spray water on a flare-up

Image 8
Contents Kenmore Electric Range Located on the plate Above Ithe top left corner Ers forSELF- Clean Ovens Surface UnitsDo not Heat Unopened Food Containers Keep Oven Vent Ducts UncoveredTabJe Conten Know your kenmore slide=in range SeriesConvertible Color Panels Nickel Plated Oven Racks Oven Lock Light 10, Oven Signal Light 11, Oven Light SwitchSurface Unit Control -- Left Front and Module Setting the Controls Control Setting GuideTo Start Operation FoodCOiL Module Removal and Replacement ModumeTo remove or replace Surface Unit Modules StepTo Install To Clean Steak GrillInstalling and Removing Plugjn Steak Grill Steak Grill noWeight or Control Approximate Cooking Time Thickness SettingCooking on top of the range alUmodels GrillModule accessories all 8 surface unit lets you fit the unit size toClock and ONE.HOUR Timer Oven CookingBAKING/ROASTING BroilingPAN Placement Offset RackRack Arrangements Normally, t I/2 to 2 inches of air space should be allowedElectric Cooking Selecting Cooking UtensilsConsider the Design Consider the MaterialHOLD-WARM Chart Holding and WarmingOVEN-COOKED Meals CasseroleBaking PROBLEMS, CAUSES, Corrections Problem ProbableCauses Too fastOven Roasting Tips Roasting ChartRoasting Broiling Food PreparationPositioning Broiler PAN Broiler FireCleaning an maintenance features Oven Door RemovalTo Remove To Replace Removable Oven RacksInstalling and Removing PLUG-IN Griddle To Clean GriddleControl Setting Guide Griddle Griddle noROTIlSHISH no Optional AccessoryTo Install Rotisserie Rotisserie To USE the Shish KebabTouse Module accessories all models Weight PositionCooking Timetable Approximate rotisserie cooking timesCleaning Procedures AluminumGLASS, Paint Plastic Porcelain EnamelMowto clean your range SELF.CLEANING OvenBefore a Cleaning Cycle To SET a Clean Cycle Stop TimeAdjusting Oven Temp Knob ProblemTo adjust oven temperature Before Calling the Servbce TechnicianCAUTnON Remove Clips and Tape -- RemoveFreestanding iNSTALLATiON BUILT-IN Installation Slide-insEConstruction Built-in installation drop-insTop View To Adjust Width of Backguard Backguard Attachment UnstructuonsRange END Panel Removal or Installation Modular RangesCoil TOP Ranges FrontPage WE Service What WE Sell Full 90-DAY Warranty on Mechanical AdjustmentsOwnership 2rid Year