Kenmore Kitchen Grill Griddle no, Installing and Removing PLUG-IN Griddle, To USE the Griddle

Page 19

modems)

All accessories are available from your Sears Catalog or Retail Store.

GRIDDLE NO. 49905

INSTALLING AND REMOVING

PLUG-IN GRIDDLE

The griddle can be used on either side.

Two griddles can be used°

CAUTION

Be sure the switch is turned OFF and the plug-in griddle or sudace unit module is cool before removing°

When removing module, lift the front just high enough to clear the front of the cooktop, to pre- vent damage to the module terminals.,

To remove module, lift up the front of module and pull it forward to unplug it at rear.

\

Replace the module by lining up the terminals on the

module with receptacle in the range Push the module into position then lower the front into place

L:::::::: : =i;

COOKING WITH

THE TEFLON ® GRIDDLE

BEFORE USING THE GRIDDLE

FOR THE FIRST TIME

tWash it with hot sudsy water, using a sponge or dishcloth Do not immerse terminals in water

2Rinse and wipe it dry

3 Brushwith a lightcoatingofcookingoil ltisnot necessary to grease the Teflon_ finish each time the griddle is used However, oil, fat or butter will add flavor to food and is an aid in browning

TO USE THE GRIDDLE

Lift and remove the griddle cover before and during cooking.

Preheat the griddle for about five minutes, The griddle is preheated when a few drops of water sprinkled on the surface will dance in little round beads, or when a bit of butter begins to brown,

To fry eggs, preheat only LJntil fat melts,

Add the food to be cooked

When the food has cooked, turn the unit off If the unit under the griddle remains on after the food is cooked, the heat may damage the Teflon 't'finish

TO CLEAN GRIDDLE

Let the griddle cool before removing it to clean.

Wash the griddle in hot water and detergent Be careful not to immerse the terminals in water_,

Do not scour it with steel wool, metal scouring pads or cleansers which wilt scratch the Teflon _" finish

Rinse and dry the griddle,

CONTROL SETTING

GUIDE - GRIDDLE

Use this table as a guide for cooking on the griddle tncrease or decrease the settings to fit your recipes. You wilt find better cooking results if you preheat the griddle five minutes before cooking

FOOD

SETTING

Eggs

4 ..5

Hamburgers

7 - HI

Bacon

8-

HI

Grilled Sandwiches

8

- HI

Pancakes

8

HI

19

Image 19
Contents Located on the plate Above Ithe top left corner Ers for Kenmore Electric RangeKeep Oven Vent Ducts Uncovered SELF- Clean OvensSurface Units Do not Heat Unopened Food ContainersTabJe Conten Series Know your kenmore slide=in rangeSurface Unit Control -- Left Front and Module Oven Lock Light 10, Oven Signal Light 11, Oven Light SwitchConvertible Color Panels Nickel Plated Oven Racks Operation Food Setting the ControlsControl Setting Guide To StartStep COiL Module Removal and ReplacementModume To remove or replace Surface Unit ModulesSteak Grill no To InstallTo Clean Steak Grill Installing and Removing Plugjn Steak GrillGrill Weight or Control Approximate Cooking TimeThickness Setting Cooking on top of the range alUmodels8 surface unit lets you fit the unit size to Module accessories allBroiling Clock and ONE.HOUR TimerOven Cooking BAKING/ROASTINGNormally, t I/2 to 2 inches of air space should be allowed PAN PlacementOffset Rack Rack ArrangementsConsider the Material Electric CookingSelecting Cooking Utensils Consider the DesignCasserole HOLD-WARM ChartHolding and Warming OVEN-COOKED MealsToo fast Baking PROBLEMS, CAUSES, CorrectionsProblem Probable CausesRoasting Roasting ChartOven Roasting Tips Broiler Fire BroilingFood Preparation Positioning Broiler PANTo Replace Removable Oven Racks Cleaning an maintenance featuresOven Door Removal To RemoveGriddle no Installing and Removing PLUG-IN GriddleTo Clean Griddle Control Setting Guide GriddleTo Install Rotisserie Optional AccessoryROTIlSHISH no Touse To USE the Shish KebabRotisserie Approximate rotisserie cooking times Module accessories all modelsWeight Position Cooking TimetablePorcelain Enamel Cleaning ProceduresAluminum GLASS, Paint PlasticTo SET a Clean Cycle Stop Time Mowto clean your rangeSELF.CLEANING Oven Before a Cleaning CycleBefore Calling the Servbce Technician Adjusting Oven Temp KnobProblem To adjust oven temperatureRemove Clips and Tape -- Remove CAUTnONBUILT-IN Installation Slide-ins Freestanding iNSTALLATiONTop View Built-in installation drop-insEConstruction Backguard Attachment Unstructuons To Adjust Width of BackguardFront Range END Panel Removal or InstallationModular Ranges Coil TOP RangesPage 2rid Year WE Service What WE SellFull 90-DAY Warranty on Mechanical Adjustments Ownership