Kenmore 790.9642 Special Caution for Aluminum Use on the Ceramic Cooktop, To Replace Oven Door

Page 23

General Care & Cleaning

Cleaning Recommendations for Ceramic Glass Cooktops (cont'd)

Do not use the following on the ceramic glass cooktop:

•Do not use abrasive cleaners and scouring pads, such as metal and some nylon pads. They may scratch the cooktop, making it more difficult to clean.

•Do not use harsh cleaners, such as chlorine bleach, ammonia or oven cleaners, as they may etch or discolor the cooktop.

•Do not use dirty sponges, cloths or paper towels, as they can leave soil or lint on the cooktop which can burn and cause discoloration.

Door Hinge locations

with oven door

fully open

Fig. 1

Fig. 2

Oven

Door

Fig. 3

Fig. 4

Special Caution for Aluminum Use on the Ceramic Cooktop:

•Aluminum Foil - Use ofaluminum foil on a hot cooktop will damage the ceramic cooktop. Do not use thin aluminum cooking utensils or allow aluminum foil to touch the ceramic cooktop under ANY circumstances.

•Aluminum utensils - The melting point of aluminum is much lower than that of other metals. Care must be taken when aluminum pots or pans are used on the cooktop. If allowed to boil dry, not only will the utensil be destroyed, but it may fuse to, break or mark the ceramic glass surface, permanently damaging the cooktop surface.

Removing and Replacing the Lift-Off Oven Door

The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.

To Remove Oven Door:

1.Open oven door completely (horizontal with floor- See Fig. 1).

2.Pull the door hinge locks on both left and right door hinges down from the oven frame completely towards the oven door (See Fig. 2). A tool such as a small flat-blade screwdriver may be required.

3.Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - See Fig. 3).

4.Close the door to the broil stop position (the oven door will stop into this position just before fully closing).

5.With the oven door in the broil stop position, lift the oven door hinge arms over the roller pins located on each side of the oven frame (See Fig. 4).

To Replace Oven Door:

1.Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - See Fig. 3).

2.Holding the oven door at the same angle as the removal position, seat the hook of the hinge arm over the roller pins located on each side of the oven door frame (See Fig. 4). The hook of the hinge arms must be fully seated onto the roller pins.

3.Fully open the oven door (horizontal with floor- See Fig. 1).

4.Push the door hinge locks up towards and into the oven frame on both left and right oven door hinges (See Fig. 2) to the locked position.

5.Close the oven door.

Special Door Care Instructions- Most oven doors contain glass that can break. Read the following recommendations:

1.Do not close the oven door until all the oven racks are fully in place.

2.Do not hit the glass with pots, pans, or any other object.

3.Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later time.

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Electric Range Estufa elctrica Table of Contents Product Record IMPORTANT--Do not attempt to operate the range during Important Safety InstructionsUtensil Handles Should Be Turned Inward and Not Extend Over Important Safety NoticeUse Care When Opening Oven Door or Warmer Drawer if Canada Your Electric Range Features Include Range FeaturesArranging Oven Racks Before Setting Oven ControlsOven Vent Location Removing & Replacing Oven RacksAbout the Radiant Surface Elements Before Setting Oven Controls contdElement on and Hot Surface Indicator Lights About the Ceramic Glass CooktopTo Operate Simmer Select Surface Element some models Setting Surface ControlsTo Operate Single Radiant Surface Elements all models To Operate Dual Radiant Surface Element some models Setting Surface Controls contdSetting the Warmer Warm & Ready TM Zone some models Recommended Food Settings Heating LevelSurface Cooking To Set the Cooktop Lockout Feature some models / CooktopUsing Power Element some models Using proper cookwarePAD-- Used Temperature conversionOven Control Functions For a silent control panelTo Set the Clock Setting Oven ControlsTo Set the Minute Timer To Change the Minute Timer while it is in useTo Set Control for Oven Lockout Lockout Setting Oven Controls contdTo Set or Change the Temperature for Baking To Set Control for Continuous Bake or 12 Hour Energy SavingWhen the Set Bake Time Runs Out To Set the Timed Bake and Delay Start FeaturesFood category To Set for BroilingTo Operate the Oven Light To set Warm & Hold to turn on automatically Setting Warmer Drawer ControlsSetting the Warm & Hold TM Feature To set Warm & HoldTo Remove and Replace Warmer Warm & Ready TM Drawer Setting Warmer Drawer Controls contdWarmer Warm & Ready TM Drawer Indicator Light some models Adhere to the following cleaning precautions Self-CleaningSelf-Cleaning Oven Stopping or Interrupting a Select Self-Cleaning Cycle Self-Cleaning contdTrim Surfaces How to CleanAluminum Trim Pieces & Vinyl For heavy, burned on soil General Care & Cleaning contdPlastic or foods with a high sugar content For light to moderate soilDoor Hinge locations With oven door Fully open Special Caution for Aluminum Use on the Ceramic CooktopTo Replace Oven Door To replace the oven light bulb Adjusting the Oven TemperatureCare and Cleaning of Stainless Steel some models Changing the Oven LightEntire Appliance Does Not operate Before You CallRange Only Oven light does not workMetal CooktopPage Call anytime, day or night U.S.A. only Call anytime, day or night U.S.A. and Canada
Top Page Image Contents