Kenmore 790.9633, 790.9631, 790.9622 manual Adjusting the Oven Temperature, Changing the Oven Light

Page 24

General Care & Cleaning

Changing the Oven Light

The oven light automatically turns ON when the door is opened. The oven light

Oven Light

Wire

Holder

may also be manually operated by pressing the @ pad.

The oven light bulb is located at the rear of the oven and is covered with a glass

shield held by a wire holder. The glass shield must be in place whenever the oven is in use.

To replace the oven light bulb:

 

 

1.

Turn electrical power off at the main source

or unplug the range.

 

 

 

2.

Press wire holder

to one side to release the glass shield.

 

 

 

3.

Replace

bulb with

a new 40 watt appliance

bulb.

 

 

 

4.

Replace

glass shield over bulb and snap wire holder into place.

back in).

9

 

5.

Turn power back on again at the main source

(or plug the range

 

..........................

6.

The clock will then

need to be reset. To reset,

see Setting the

Clock and

 

 

Minute Timer in this Use & Care Guide.

Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a leather-faced glove for protection against possible broken glass.

Care and Cleaning of Stainless Steel (some models)

Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the appearance of stainless parts. Refer to the Care & Cleaning Table for detailed cleaning instructions.

Adjusting the Oven Temperature

Your oven control has been precisely set at the factory. This setting may differ from your previous oven however, so your recipe times may not give you the results you expect. If you think that the oven is cooking too hot or too cool for your recipe times, you can adjust the control so that the oven cooks hotter or cooler than the temperature displayed.

To Adjust Oven Temperature:

1.Press Bake,

2.Set the temperature to 550°F (287°C) by pressing and holding the /%.

3.Within 2 seconds, press and hold _Bakeuntil the 2 digit display appears. Release B,_k The. display now indicates the amount

of degrees offset between the original factory temperature setting and the current temperature setting. If the oven control has the original factory calibration, the display will read "0."

4.Thetemperaturecann_wbeadjustedup_rd_wn35°F(17°c),in5°Fstepsbypressingandh__dingthe/% or V. Adjust

until the desired amount of offset appears in the display. When lowering the oven temperature, a minus sign (-) will appear before the number to indicate that the oven will be cooler by the displayed amount of degrees.

5.When you have made the desired adjustment, press _ to go back to the time of day display.

Note: Oven temperature adjustments made will not change the Self-Cleaning feature temperature.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Electric Range Estufa elctrica Table of Contents Product Record Important Safety Instructions IMPORTANT--Do not attempt to operate the range duringImportant Safety Notice Use Care When Opening Oven Door or Warmer Drawer ifUtensil Handles Should Be Turned Inward and Not Extend Over Canada Range Features Your Electric Range Features IncludeBefore Setting Oven Controls Oven Vent LocationRemoving & Replacing Oven Racks Arranging Oven RacksBefore Setting Oven Controls contd Element on and Hot Surface Indicator LightsAbout the Ceramic Glass Cooktop About the Radiant Surface ElementsSetting Surface Controls To Operate Single Radiant Surface Elements all modelsTo Operate Simmer Select Surface Element some models Setting Surface Controls contd Setting the Warmer Warm & Ready TM Zone some modelsRecommended Food Settings Heating Level To Operate Dual Radiant Surface Element some modelsTo Set the Cooktop Lockout Feature some models / Cooktop Using Power Element some modelsUsing proper cookware Surface CookingTemperature conversion Oven Control FunctionsFor a silent control panel PAD-- UsedSetting Oven Controls To Set the Minute TimerTo Change the Minute Timer while it is in use To Set the ClockSetting Oven Controls contd To Set or Change the Temperature for BakingTo Set Control for Continuous Bake or 12 Hour Energy Saving To Set Control for Oven Lockout LockoutTo Set the Timed Bake and Delay Start Features When the Set Bake Time Runs OutTo Set for Broiling To Operate the Oven LightFood category Setting Warmer Drawer Controls Setting the Warm & Hold TM FeatureTo set Warm & Hold To set Warm & Hold to turn on automaticallySetting Warmer Drawer Controls contd Warmer Warm & Ready TM Drawer Indicator Light some modelsTo Remove and Replace Warmer Warm & Ready TM Drawer Self-Cleaning Self-Cleaning OvenAdhere to the following cleaning precautions Self-Cleaning contd Stopping or Interrupting a Select Self-Cleaning CycleSurfaces How to Clean Aluminum Trim Pieces & VinylTrim General Care & Cleaning contd Plastic or foods with a high sugar contentFor light to moderate soil For heavy, burned on soilSpecial Caution for Aluminum Use on the Ceramic Cooktop To Replace Oven DoorDoor Hinge locations With oven door Fully open Adjusting the Oven Temperature Care and Cleaning of Stainless Steel some modelsChanging the Oven Light To replace the oven light bulbBefore You Call RangeEntire Appliance Does Not operate Oven light does not work MetalCooktop OnlyPage Call anytime, day or night U.S.A. and Canada Call anytime, day or night U.S.A. only
Top Page Image Contents