Kenmore 2200128 manual Refrigerator Features, Ice dispenser

REFRIGERATOR

FEATURES

To remove the ice bin:

1.Pull the covering panel out from the bottom and then slide it back toward the rear.

2.Lift the signal arm so it clicks into the OFF (up) position. Ice can still be dispensed, but no more can be made.

3.Lift up the front of the storage bin and pull it out.

4.Empty the ice bin. Use warm water to melt the ice if necessary. Never use anything sharp to break up the ice in the bin. This can cause damage to the bin and the dispenser mechanism.

5.Wash with a mild detergent, rinse well and dry thoroughly. Do not use harsh or abrasive cleaners or solvents.

6.When you replace the bin, make sure it is pushed in all the way or the dispenser will not work. Then push the signal arm down to the ON position to restart ice production. Make sure the door is closed tightly.

(on s e modes

Cut Hazard

Use a sturdy glass when dispensing ice or water. Failure to do so can result in cuts.

Depending on your model, you may have one or more of the following options: the ability to select either crushed or cubed ice, a special light that turns on when you use the dispenser, or a lock option to avoid accidental dispensing.

The ice dispenser

Ice dispenses from the ice maker storage bin in the freezer. When the dispenser lever is pressed:

•A trapdoor opens in a chute between the dispenser and the ice bin.

•Ice moves from the bin and falls through the chute.

•When you release the dispenser lever, the trap door closes and the ice dispensing stops. The dispensing system will not operate when the freezer door is open.

Some models dispense both cubed and crushed ice. Before dispensing ice, select which type of ice you prefer. The button controls are designed for easy use and cleaning.

•For cubed ice, press the CUBE button until the red

indicator appears in the window above the CUBE button.

ICE

CRUSH CUBE

•For crushed ice, press the CRUSH button until the red

indicator appears in the window above the CRUSH button.

For crushed ice, cubes are crushed before being dispensed. This may cause a slight delay when dispensing crushed ice. Noise from the ice crusher is normal, and

pieces of ice may vary in size. When changing from CRUSH to CUBE, a few ounces of crushed ice will be

dispensed along with the first cubes.

13