Kenmore 2200128, Refrigerator Recommended Grounding Method, Remove Screw 1 AS Shown in Diagram

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

Before you move your refrigerator into its final location, it is important to make sure you have the proper electrical connection:

@

Ill&

Electrical Shock Hazard

Disconnect power before removing doors.

Failure to do so can result in death or electrical shock.

NOTE: Before removing doors, open both doors and remove base grille (see the "Base Grille" section).

Tools Needed:

V4-inchhex-head socket wrench and 5/_6-inchhex-head socket wrench.

1.Unplug refrigerator or disconnect power supply.

2.If you have a dispenser (ice or water), disconnect water line (behind base grille).

•Remove hose from clip.

•Disconnect union nut and slide it back onto tube.

•Remove metal insert from tube.

•Remove union nut and spring.

Recommended Grounding Method

A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused, grounded electrical supply is required. It is recommended

that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord.

NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the Thermostat Control (or Refrigerator Control depending on the model) to OFF and

then disconnect the refrigerator from the electrical source. When you are finished, reconnect the refrigerator to the

electrical source and reset the Thermostat Control (or Refrigerator Control) to the desired setting.

\

3.Remove left top hinge.

•Remove hinge cover and screws. DO NOT

REMOVE SCREW 1 AS SHOWN IN DIAGRAM.

•Disconnect wiring plug and both ground wires.

•Carefully lift door up off bottom hinge. Make sure you protect water line from damage.

6