Kenmore 2200128 manual Using the dispenser without the water filter, Ordering replacement filters

Using the dispenser without the water filter

You can run the dispenser without a water filter cartridge. Your water will not be filtered. If you run the dispenser without a water filter cartridge, keep the cartridge cap and replace it in the base grille for future use.

1.Remove the water filter cartridge (See "Changing a water filter cartridge" earlier in this section.) Then slide

the cartridge cap off the end of the filter cartridge. DO NOT DISCARD THE CAR

2.With the cartridge cap in the vertical position, insert the cap into the base grille until it stops.

3.Rotate the cartridge cap to a horizontal position.

NOTE: The cartridge cap may not be even with the base grille.

Ordering replacement filters

To order more water filter cartridges, call 1-800-366-PART and ask for accessory Part #4392857.

The shelves in your refrigerator are adjustable to meet your individual storage needs.

Storing similar food items together in your refrigerator and adjusting the shelves to fit different heights of items will make finding the exact item you want easier. It will also reduce the amount of time the refrigerator door is open, and save energy.

IMPORTANT: Do not clean glass shelves with warm water when they are cold. Shelves may break if exposed to sudden temperature changes or impact. For your protection tempered glass is designed to shatter into many small pebble-size pieces. This is normal.

NOTE: Glass shelves are heavy. Use special care when removing them to avoid impact from dropping.

To remove shelves from the shipping position (shelves are shipped upside down):

1.Grasp front of upper shelf with one hand and use other hand to remove packing material from shelf area.

2.Lower front of upper shelf until shelf hooks can be removed from slots in shelf supports on the back refrigerator wall. Pull shelf forward to remove.

3.Flip shelf over.

4.Insert rear shelf hooks into slots in shelf supports.

5.Tilt front of shelf up until rear hooks drop into slots.

6.Lower front of shelf. Check to make sure that shelf is securely in position.

Slide-out shelves (on some models)

Some shelves slide out, providing easier access to foods stored in back.

To slide out shelf, carefully pull front of shelf toward

you.

To slide in shelf, push shelf in until it stops,

To remove a shelf from the metal frame:

1.Pull shelf out to the stop.

2.Tilt front of the shelf up and pull it out a little further.

3.Lift up shelf so that it moves through the slot in the frame.

Replace the shelf in the reverse order.

Shelves and shelf frames

To remove a shelf/frame:

1.Tilt up front of the shelf/frame.

2.Pull shelf/frame.

To replace a shelf/frame:

1.Guide the rear shelf hooks into the slots in the shelf supports on the back refrigerator wall.

2.Tilt up front of shelf/frame.

3.Lower the front of the shelf into position.

16