Kenmore 2200128 manual Refrigerator light bulbs, Partcomments

•Additional cleaning tips are listed below:

PARTCOMMENTS

Light behind control panel:

1.	Unplug refrigerator or disconnect power.
2.	Reach behind the Control Panel and remove the bulb.

Outside

Inside walls

(allow freezer

to warm up so cloth won't

stick)

Door liners and gaskets

Plastic parts (covers and panels)

Condenser coils

•Waxing external painted metal surfaces helps provide rust protection. Do not wax plastic parts. Wax painted metal surfaces at least twice a year using appliance wax (or auto paste wax). Apply wax with a clean, soft cloth.

To help remove odors, you can wash with a mixture of warm water

and baking soda (2 tbs to 1 qt [26 g to .95 L] of water).

•Do not use cleaning waxes, concentrated detergents, bleaches, or cleaners containing petroleum on plastic parts.

•Do not use paper towels, window

sprays, scouring cleansers or flammable fluids. These can scratch or damage material.

•Remove base grille. (See the "Base Grille" section.)

•Use a vacuum with an extended attachment to clean condenser coils.

Vacuum coils when dusty or dirty. Coils may need to be cleaned as often as every other month.

•Replace base grille.

3. Replace the bulb with a 40-watt appliance bulb.

4.Plug in refrigerator or reconnect power. Crisper light (on some models):

1.Unplug refrigerator or disconnect power.

2.Pull the top of the light shield forward until it snaps free and lower it until the light bulb is visible.

3.Replace the bulb with a 40-watt appliance bulb.

4.Pull the top of the light shield up over the bulb and snap it onto the side wall supports.

5.Plug in refrigerator or reconnect power.

To remove light shield for cleaning:

NOTE: Not all appliance bulbs will fit your refrigerator. Be sure to replace the bulb with one of the same size and shape.

Refrigerator light bulbs

Dispenser area light (on some models):

1.Unplug refrigerator or disconnect power.

2.Reach through the dispenser area to remove the bulb.

3.Replace the bulb with a heavy-duty 10-watt bulb, which can be purchased from your dealer.

4.Plug in refrigerator or reconnect power.

1.Remove the crisper and the crisper cover.

2.Release the bottom of the shield from the lower side wall supports.

3.Pull the light shield out from above the crisper cover and wash it with warm water and a liquid detergent.

4.Rinse and dry the cover.

5.Push the light shield up over the bulb and snap it into the side wall supports.

Freezer light bulbs

Light below the ice bin:

1.Unplug refrigerator or disconnect power.

2.Push in the sides of the light shield and pull down until the shield snaps free.

21