Craftsman 917.27084 AIR Filter, To Service PRE-CLEANER, To Service Cartridge, Engine Cooling RNS

Page 22

AIR FILTER

Your engine will not run properly using 8 dirty air filter. Clean the foam pre-cleaner

after every 25 hours of operation or every season. Service paper cartridge every

100 hours of operation or every season, whichever occurs first.

Service air cleaner more often under dusty conditions.

Remove knob(s) and cover.

TO SERVICE PRE-CLEANER

Slide foam pre-cleaner off cartridge.

Wash it in liquid detergent and water.

Squeeze it dry in a clean cloth.

Saturate it in engine oil. Wrap it in

clean, absorbent cloth and squeeze to remove excess oil.

if very dirtyor damaged, replace pre- cleaner.

Reinstall pre-cleaner over cartridge.

Reinstall cover and secure with knob(s).

TO SERVICE CARTRIDGE

Remove wing nuts and cartridge plate.

Carefully remove cartridge to prevent debris from entering carburetor.

Clean cartridge by tapping gently on flat surface. If very dirty or damaged, replace cartridge.

Reinstall cartridge plate, wing nuts, pre-

cleaner, cover and secure with knob(s), IMPORTANT: Petroleum solvents, such

as kerosene, are not to be used to clean the cartridge. They may cause deteriora- tion of the cartridge. Do not oil cartridge. Do not use pressurized air to clean or dry cartridge.

Knob

Wing Nut

Plate

Foam Pre-

Cleaner

Air Screen

ENGINE COOLING RNS

Remove any dust, dirt or oil from engine cooling fins to prevent engine damage from overheating. Air guJdecovers must be removed. Remove side panels and hood (See "TO REMOVE HOOD AND

GRILL ASSEMBLY" in the Service and Ad- justments section of this manual).

Top Air Guide_

Engine Cooling

Air Guide Cover

(Both Sides)

MUFFLER

Inspect and replace corroded muffler and spark attester (if equipped) as it could cre- ate a fire hazard and/or damage.

SPARK PLUGS

Replace spark plugs at the beginning of each mowing season or after every 100 hours Of operation, whichever occurs first. Spark plug type and gap setting are shown in =PRODUCT SPECIFICATIONS" on page 5 of this manual.

IN-LINE FUEL RLTER

The fuel filter should be replaced once each season. If fuel filter becomes

clogged, obstructing fuel flow to carbure- tor, replacement is required.

With engine cool, remove filter and plug fuel line sections.

Place new fuel filter in position in fuel line with arrow pointing towards carbu- retor.

Be sure there are no fuel line leaks and clamps are properly positioned.

22

Image 22
Contents CRAFTSMAN+ Sears Craftsman Help Line 5 am 5 pm, Mon- SatProduct Specifications Repair Parts Parts Ordering Back CoverSafety Limited 90 DAY Warranty on BatterySlope Operation ServiceChildren Do notTY is Involved Product Specifications Maintenance Agreement16 x Parts Bag contents shown full sizeHex Bolt 5116-18 x 1-1/4 Hex BoAtParts Bag contents not shown full size Parts packed separately in cartonTools Required for Assembly Before Rolling Tractor OFF SkidInstall Seat HOW to SET UP Your TractorCheck Battery Adjustment KnobTo Convert to Bagging or Discharging HooksCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemH L Page Ground Drive HOW to USE Your TractorMower Blades EngineTo Operate Mower Towing Carts and Other AttachmentsTo Transport To Operate on HillsBefore Starting the Engine Be sure the tractor is on level ground Mowing TipsRGE Transmission Avoid cutting your lawn when it is wet Customer Responsibilities Lubrication ChartMaintenance Schedule Before Each USEBrakeoperation To Sharpen BladeEngine AIR Filter To Service PRE-CLEANERTo Service Cartridge Engine Cooling RNSFuel Filter CleaningTo Install Mower To Remove MowerFRONT-TO-BACK Adjustment To LevelmowerhousingSIDE-TO-SIDE Adjustment To Replace Mower Blade DriveStationaryIdler Transmission BeltinstallationTo Adjust Brake To Replace Motion Drive Belt Engine Pulley Clutching IdlerFront Wheel TOE-IN/CAMBER To Start Engine with a Weak BatteryRRANSMISSION REMOVAL/REPLACE- Ient To Remove Wheel for RepairsTo Replace Headlight Bulb Replacing BatteryTo Remove CABLES, Reverse Order Interlocks and RelaysTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control Final SettingTractor Acceleration TestFuel System Cylinders OtherProblem Cause Roubleshooting ChartCorrection Troubleshooting Chart ProblemCheck tires for proper air pres Reinstall blades sharp edgeBattery will not charge Loss of ddve SureTractor --MODEL Number Tractor - Model Number Electrical KEY Part DescriptionTractor - Model Number Chassis and Enclosures Tractor - Model Number Chassis and Enclosures KEY Part NO. NO.DESCRIPTIONTractor - Model Number Rounddrive Bo,ng TRACTOR- Model NumberGaLe Ground Drive KEY Part DescriptionTractor - Model Number Steeringassembly Tractor - Model Number Steering Assembly KEY Part DescriptionOptional Equipment NgineSpark Arrester Oarm Hose B Engine KEY Part DescriptionInch 25A mm KEY Part NO. no Tractor - Model Number 917.270840 SeatassemblySpacers128 x 9snc KEY PartWheels & Tires DecalsTractor -- Model Number OneTractor - Model Number IFT Assembly 1718 15 ,.\ 16\\Tractor - Model Number Lift Assembly Tractor - Model Number Mower Deck Ng. p Ang, BallTractor - Model Number Iydro Gear Transaxle - Model Number Tractor - Model Number Hydro Gear Transaxle - Model Number 2set 11010LABELKrr J 5i7,2,2 o3 Gasket SET 513 803797A797 544801 634Spring-ValveExhaust Seal-OilBody KEY Part NO. NO. DescriptionSchematic TW,N CYL BiginesPage Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across HillSears

917.27084 specifications

The Craftsman 917.27084 is a versatile lawn tractor that represents the brand's commitment to quality, performance, and ease of use. Known for its powerful engine and user-friendly design, the Craftsman 917.27084 is an ideal choice for homeowners looking to maintain their lawns with efficiency and precision.

At the heart of the 917.27084 is a robust 24 horsepower Briggs & Stratton engine. This engine provides ample power for various mowing tasks while ensuring durability and reliability. The engine is equipped with a hydrostatic transmission system, allowing for smooth acceleration and effortless control, making it easier to navigate around obstacles and tight spaces in your yard.

One of the standout features of the Craftsman 917.27084 is its cutting deck. It boasts a 42-inch cutting width, allowing for efficient mowing of medium to large-sized lawns. The deck is adjustable to multiple cutting heights, giving users the flexibility to achieve their desired lawn appearance. This adaptability is particularly beneficial for those who prefer a well-manicured lawn or want to tailor the cut for different grass types or seasonal needs.

The tractor also includes a comfortable and spacious operator's seat, which is designed for extended use without causing fatigue. The ergonomic steering wheel and control layout further enhance the user experience by making it easy to maneuver the tractor.

Safety is a critical concern with any lawn equipment, and the Craftsman 917.27084 does not disappoint. It includes features such as an automatic safety shut-off system that activates the engine when the operator leaves the seat, minimizing the risk of accidents. Additionally, the front and rear wheels are designed with enhanced traction, ensuring stability on various terrains.

Furthermore, the Craftsman 917.27084 incorporates advanced technology for improved performance. The Easy Start system means that users can quickly get the engine running without hassle. The maintenance-free battery and integrated LED headlights add convenience and increase usability, making it easier to mow at any time of day or in low-light conditions.

Overall, the Craftsman 917.27084 combines power, comfort, and advanced features, making it a reliable choice for lawn care enthusiasts. Whether you have a small yard or a larger property, this lawn tractor provides the right balance of performance and user-friendly design. It’s an investment that simplifies lawn maintenance, allowing you to spend less time mowing and more time enjoying your outdoor space.