Craftsman 917.27084 To Remove CABLES, Reverse Order, Replacing Battery, To Replace Headlight Bulb

Page 27

TO ATTACH JUMPER CABLES -

•Connect each end of the RED cable to the POSITIVE (+) terminal of each bat-

tery, taking care not to short against chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal of fully charged battery.

•Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

=Positive" (+)

"Negative" (-)

L.H.Panel _-_1

/

Bolt

 

REPLACING BATTERY

&,CAUTION: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch

bands,rings,etc.

Positive terminal must be connected first to prevent sparking from accidental grounding.

•Lift hood to raised position.

•Remove terminal guard.

•Disconnect BLACK battery cable then RED battery Cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•Reinstall terminal guard.

•First connect RED battery cable to posi- tive (+) battery terminal with hex bolt

and keps nut as shown. Tighten secure-

ly.

•Connect BLACK grounding cable to negative (-) battery terminal with

remaining hex bolt and keps nut.

Tighten securely.

•Close terminal access doom.

•Close hood.

Hex Bolt

Terminal Kep_ut

Access ....._:..-----_._

Door _}_i---. ,--i.i°i

Termin_

Is

(Black) Cable

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or pre- vent it from starting.

•Check wiring. See electrical wiring dia- gram in the Repair Parts section of this manual.

TO REPLACE FUSE

Replace with 30 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Sears Craftsman Help Line 5 am 5 pm, Mon- Sat CRAFTSMAN+Limited 90 DAY Warranty on Battery Repair Parts Parts Ordering Back CoverSafety Product SpecificationsDo not ServiceChildren Slope OperationTY is Involved Maintenance Agreement Product SpecificationsHex BoAt Parts Bag contents shown full sizeHex Bolt 5116-18 x 1-1/4 16 xParts packed separately in carton Parts Bag contents not shown full sizeBefore Rolling Tractor OFF Skid Tools Required for AssemblyAdjustment Knob HOW to SET UP Your TractorCheck Battery Install SeatHooks To Convert to Bagging or DischargingCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsH L Page Engine HOW to USE Your TractorMower Blades Ground DriveTo Operate on Hills Towing Carts and Other AttachmentsTo Transport To Operate MowerBefore Starting the Engine Mowing Tips Be sure the tractor is on level groundRGE Transmission Avoid cutting your lawn when it is wet Before Each USE Lubrication ChartMaintenance Schedule Customer ResponsibilitiesTo Sharpen Blade BrakeoperationEngine Engine Cooling RNS To Service PRE-CLEANERTo Service Cartridge AIR FilterTo Remove Mower CleaningTo Install Mower Fuel FilterTo Replace Mower Blade Drive To LevelmowerhousingSIDE-TO-SIDE Adjustment FRONT-TO-BACK AdjustmentEngine Pulley Clutching Idler BeltinstallationTo Adjust Brake To Replace Motion Drive Belt StationaryIdler TransmissionTo Remove Wheel for Repairs To Start Engine with a Weak BatteryRRANSMISSION REMOVAL/REPLACE- Ient Front Wheel TOE-IN/CAMBERInterlocks and Relays Replacing BatteryTo Remove CABLES, Reverse Order To Replace Headlight BulbFinal Setting To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorAcceleration Test TractorFuel System Other CylindersRoubleshooting Chart Problem CauseCorrection Problem Troubleshooting ChartSure Reinstall blades sharp edgeBattery will not charge Loss of ddve Check tires for proper air presTractor --MODEL Number Electrical KEY Part Description Tractor - Model NumberTractor - Model Number Chassis and Enclosures KEY Part NO. NO.DESCRIPTION Tractor - Model Number Chassis and EnclosuresTractor - Model Number Rounddrive Ground Drive KEY Part Description TRACTOR- Model NumberGaLe Bo,ngTractor - Model Number Steeringassembly KEY Part Description Tractor - Model Number Steering AssemblyNgine Optional EquipmentSpark Arrester Engine KEY Part Description Oarm Hose BInch 25A mm KEY Part Tractor - Model Number 917.270840 SeatassemblySpacers128 x 9snc KEY Part NO. noOne DecalsTractor -- Model Number Wheels & Tires1718 15 ,.\ 16\\ Tractor - Model Number IFT AssemblyTractor - Model Number Lift Assembly Tractor - Model Number Mower Deck Ang, Ball Ng. pTractor - Model Number Iydro Gear Transaxle - Model Number Tractor - Model Number Hydro Gear Transaxle - Model Number 2set 11010LABELKrr J 5i7,2,2 o3 634 513 803797A797 544801 Gasket SETSeal-Oil Spring-ValveExhaustKEY Part NO. NO. Description BodyTW,N CYL Bigines SchematicPage Only Ride UP and Down Hill Not Across Hill Suggested Guide for Sighting Slopes for Safe OperationSears

917.27084 specifications

The Craftsman 917.27084 is a versatile lawn tractor that represents the brand's commitment to quality, performance, and ease of use. Known for its powerful engine and user-friendly design, the Craftsman 917.27084 is an ideal choice for homeowners looking to maintain their lawns with efficiency and precision.

At the heart of the 917.27084 is a robust 24 horsepower Briggs & Stratton engine. This engine provides ample power for various mowing tasks while ensuring durability and reliability. The engine is equipped with a hydrostatic transmission system, allowing for smooth acceleration and effortless control, making it easier to navigate around obstacles and tight spaces in your yard.

One of the standout features of the Craftsman 917.27084 is its cutting deck. It boasts a 42-inch cutting width, allowing for efficient mowing of medium to large-sized lawns. The deck is adjustable to multiple cutting heights, giving users the flexibility to achieve their desired lawn appearance. This adaptability is particularly beneficial for those who prefer a well-manicured lawn or want to tailor the cut for different grass types or seasonal needs.

The tractor also includes a comfortable and spacious operator's seat, which is designed for extended use without causing fatigue. The ergonomic steering wheel and control layout further enhance the user experience by making it easy to maneuver the tractor.

Safety is a critical concern with any lawn equipment, and the Craftsman 917.27084 does not disappoint. It includes features such as an automatic safety shut-off system that activates the engine when the operator leaves the seat, minimizing the risk of accidents. Additionally, the front and rear wheels are designed with enhanced traction, ensuring stability on various terrains.

Furthermore, the Craftsman 917.27084 incorporates advanced technology for improved performance. The Easy Start system means that users can quickly get the engine running without hassle. The maintenance-free battery and integrated LED headlights add convenience and increase usability, making it easier to mow at any time of day or in low-light conditions.

Overall, the Craftsman 917.27084 combines power, comfort, and advanced features, making it a reliable choice for lawn care enthusiasts. Whether you have a small yard or a larger property, this lawn tractor provides the right balance of performance and user-friendly design. It’s an investment that simplifies lawn maintenance, allowing you to spend less time mowing and more time enjoying your outdoor space.
Top Page Image Contents