Craftsman 917.27084 manual HOW to USE Your Tractor, Mower Blades, Ground Drive, Engine

Page 14

Theoperationof any tractorcan resultin foreignobjectsthrownintothe eyes,whichcan resultin severeeye damage.Alwayswearsafetyglasses

or eye shieldswhileoperatingyour tractororperformingany adjustmentsor repairs.We recommendawidevisionsafetymaskoverspectacles,orstan- dardsafetyglasses.

HOW TO USE YOUR TRACTOR

Your tractor is equipped with an operator presence sensing switch. When engine is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine.

TO SET PARKING BRAKE

Depress clutch/brake pedal into full =BRAKE" position and hold.

Place parking brake lever in =EN-

GAGED" position and release pressure from clutch/brake pedal. Pedal should remain in =BRAKE" position. Make sure parking brake will hold tractor secure.

NOTE: Failure to move throttle control to slow position and allowing engine to idle

before stopping may cause engine to Ubackfire".

Turn ignition key to "OFF" position and remove key. Always remove key when leaving tractor to prevent unauthorized use.

Never use choke to stop engine.

IMPORTANT: Leaving the ignition switch in any position other than "OFF" will cause the battery to be discharged, (dead).

NOTE: Under certain conditions when tractor is standing idle with the engine run- ning, hot engine exhaust gases may

Choke

Attachment Clutch

cause Ubrewning" of grass. To eliminate

ControlLever =Engaged"

Position

=Disengaged"

Control

Parking Brake

=Brake"

Position

Motion

Pedal =Drive" "Diser_gaged" Control

Position PositionLever

STOPPING

MOWER BLADES -

To stop mower blades, move attach- ment clutch lever to =DISENGAGED"

position.

GROUND DRIVE-

To stop ground drive, depress clutch/brake pedal into full =BRAKE" position.

Move motion control lever to neutral (N)

position.

IMPORTANT: The motion control lever does not retum to neutral (N) position when the clutch/brake pedal is depressed.

ENGINE -

Move throttle control to slow position.

this possibility, always stop engine when stopping tractor on grass areas.

CAUTION: Always stop tractor com- pletely, as described above, before leaving the operator's position; to empty grass catcher, etc:

THROTTLE CONTROL

Always operate engine at full throttle.

Operating engine at less than full throt- tle reduces the battery charging rate.

Full throttle offers the best bagging and

mower performance.

CHOKE CONTROL

Use choke control whenever you are start- ing a cold engine. Do not use to start a warm engine.

To engage choke control, pull knob out. Slowly push knob in to disengage,

TO MOVE FORWARD AND BACKWARD The direction and speed of movement is controlled by the motion control lever.

Start tractor with motion control lever in neutral (N) position.

Release parking brake and clutch/brake

pedal.

Slowly move motion control lever to

desired position.

NOTE: The effort to move the motion con- trol lever will reduce after the first few hours of use. This is normal.

TO ADJUST MOWER CU'I'rlNG HEIGHT The cutting height is controlled by tuming the height adjustment knob in desired

14 direction.

Image 14
Contents CRAFTSMAN+ Sears Craftsman Help Line 5 am 5 pm, Mon- SatProduct Specifications Repair Parts Parts Ordering Back CoverSafety Limited 90 DAY Warranty on BatterySlope Operation ServiceChildren Do notTY is Involved Product Specifications Maintenance Agreement16 x Parts Bag contents shown full sizeHex Bolt 5116-18 x 1-1/4 Hex BoAtParts Bag contents not shown full size Parts packed separately in cartonTools Required for Assembly Before Rolling Tractor OFF SkidInstall Seat HOW to SET UP Your TractorCheck Battery Adjustment KnobTo Convert to Bagging or Discharging HooksCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemH L Page Ground Drive HOW to USE Your TractorMower Blades EngineTo Operate Mower Towing Carts and Other AttachmentsTo Transport To Operate on HillsBefore Starting the Engine RGE Transmission Mowing TipsBe sure the tractor is on level ground Avoid cutting your lawn when it is wet Customer Responsibilities Lubrication ChartMaintenance Schedule Before Each USEBrakeoperation To Sharpen BladeEngine AIR Filter To Service PRE-CLEANERTo Service Cartridge Engine Cooling RNSFuel Filter CleaningTo Install Mower To Remove MowerFRONT-TO-BACK Adjustment To LevelmowerhousingSIDE-TO-SIDE Adjustment To Replace Mower Blade DriveStationaryIdler Transmission BeltinstallationTo Adjust Brake To Replace Motion Drive Belt Engine Pulley Clutching IdlerFront Wheel TOE-IN/CAMBER To Start Engine with a Weak BatteryRRANSMISSION REMOVAL/REPLACE- Ient To Remove Wheel for RepairsTo Replace Headlight Bulb Replacing BatteryTo Remove CABLES, Reverse Order Interlocks and RelaysTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control Final SettingFuel System Acceleration TestTractor Cylinders OtherCorrection Roubleshooting ChartProblem Cause Troubleshooting Chart ProblemCheck tires for proper air pres Reinstall blades sharp edgeBattery will not charge Loss of ddve SureTractor --MODEL Number Tractor - Model Number Electrical KEY Part DescriptionTractor - Model Number Chassis and Enclosures Tractor - Model Number Chassis and Enclosures KEY Part NO. NO.DESCRIPTIONTractor - Model Number Rounddrive Bo,ng TRACTOR- Model NumberGaLe Ground Drive KEY Part DescriptionTractor - Model Number Steeringassembly Tractor - Model Number Steering Assembly KEY Part DescriptionSpark Arrester NgineOptional Equipment Inch 25A mm Engine KEY Part DescriptionOarm Hose B KEY Part NO. no Tractor - Model Number 917.270840 SeatassemblySpacers128 x 9snc KEY PartWheels & Tires DecalsTractor -- Model Number OneTractor - Model Number IFT Assembly 1718 15 ,.\ 16\\Tractor - Model Number Lift Assembly Tractor - Model Number Mower Deck Ng. p Ang, BallTractor - Model Number Iydro Gear Transaxle - Model Number Tractor - Model Number Hydro Gear Transaxle - Model Number 2set 11010LABELKrr J 5i7,2,2 o3 Gasket SET 513 803797A797 544801 634Spring-ValveExhaust Seal-OilBody KEY Part NO. NO. DescriptionSchematic TW,N CYL BiginesPage Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across HillSears

917.27084 specifications

The Craftsman 917.27084 is a versatile lawn tractor that represents the brand's commitment to quality, performance, and ease of use. Known for its powerful engine and user-friendly design, the Craftsman 917.27084 is an ideal choice for homeowners looking to maintain their lawns with efficiency and precision.

At the heart of the 917.27084 is a robust 24 horsepower Briggs & Stratton engine. This engine provides ample power for various mowing tasks while ensuring durability and reliability. The engine is equipped with a hydrostatic transmission system, allowing for smooth acceleration and effortless control, making it easier to navigate around obstacles and tight spaces in your yard.

One of the standout features of the Craftsman 917.27084 is its cutting deck. It boasts a 42-inch cutting width, allowing for efficient mowing of medium to large-sized lawns. The deck is adjustable to multiple cutting heights, giving users the flexibility to achieve their desired lawn appearance. This adaptability is particularly beneficial for those who prefer a well-manicured lawn or want to tailor the cut for different grass types or seasonal needs.

The tractor also includes a comfortable and spacious operator's seat, which is designed for extended use without causing fatigue. The ergonomic steering wheel and control layout further enhance the user experience by making it easy to maneuver the tractor.

Safety is a critical concern with any lawn equipment, and the Craftsman 917.27084 does not disappoint. It includes features such as an automatic safety shut-off system that activates the engine when the operator leaves the seat, minimizing the risk of accidents. Additionally, the front and rear wheels are designed with enhanced traction, ensuring stability on various terrains.

Furthermore, the Craftsman 917.27084 incorporates advanced technology for improved performance. The Easy Start system means that users can quickly get the engine running without hassle. The maintenance-free battery and integrated LED headlights add convenience and increase usability, making it easier to mow at any time of day or in low-light conditions.

Overall, the Craftsman 917.27084 combines power, comfort, and advanced features, making it a reliable choice for lawn care enthusiasts. Whether you have a small yard or a larger property, this lawn tractor provides the right balance of performance and user-friendly design. It’s an investment that simplifies lawn maintenance, allowing you to spend less time mowing and more time enjoying your outdoor space.