Enterasys Networks 8000/8600 manual Port show port status se.x.y where x is the chassis

Installing the Hardware

Table 19. Line card installation notes (Continued)

Minimum	Restrictions	Special Instructions
Firmware

SSR-SERC-04-AA E8.3.0.0 CLI Setup

Enter the following command at the CLI before implementing any configurations.

1.Type the following from Enable mode to enter Configuration mode

Enable -> Configure #

2.You may now begin configuring ports on the SSR-SERC-04-AA. Refer to the Enterasys X-Pedition Command Line Interface Reference Manual for details.

Proper Boot Sequence

•Firmware loads.

•The control module for the chassis should indicate that the SSR-SERC-04-AA was detected and is operating correctly.

•The Online LED will turn on and remain lit (no other LEDs should illuminate during module power-up).

Common Errors

•The ER16-SERC-04-AA is not inserted properly or seated completely in the chassis

•Connectors for the connected lines are not seated properly.

Helpful CLI Commands for Debugging

				•	System show hardware
				•	System show version
				• Port show port status se.x.y (where x is the chassis
					slot that contains the line card and y is a specific port
					number on the card).
				•	System show bootlog
SSR-SERCE-04-AA	E8.3.0.0	CLI Setup		Proper Boot Sequence
		Enter the following command at the CLI before		•	Firmware loads.
		implementing any configurations.		• The control module for the chassis should indicate
		1.	Type the following from Enable mode to enter		that the SSR-SERCE-04-A was detected and is
					operating correctly.
			Configuration mode
				•	The Online LED will turn on and remain lit (no other
			Enable -> Configure #
		2.	You may now begin configuring ports on the		LEDs should illuminate during module power-up).
			SSR-SERCE-04-A. Refer to the Enterasys	Common Errors
			X-Pedition Command Line Interface Reference
			Manual for details.	• The ER16-SERCE-04-A is not inserted properly or
					seated completely in the chassis
				• Connectors for the connected lines are not seated
					properly.
				Helpful CLI Commands for Debugging
				•	System show hardware
				•	System show version
				• Port show port status se.x.y (where x is the chassis
					slot that contains the line card and y is a specific port
					number on the card).
				•	System show bootlog

76 Enterasys X-Pedition 8000/8600 Getting Started Guide