DC Power Supply
The X-Pedition DC power supply delivers 3.3, 5, and 12 volts DC to the X-Pedition’s control module(s), fan modules, and other components. A single DC power supply provides enough current to operate a fully configured chassis—with the exception of certain line cards. For information about these cards, refer to Installing Line Cards on page 71.
Figure 6 shows the front view of an X-Pedition 8000 DC power supply.
To be installed in a restricted ! access area in accordance
with the NEC or authority having jurisdiction.
See manual for installation
PWR instructions.
48/60V 
14A MAX
SSR-PS-8-DC
SN 
Figure 6. Front view of an X-Pedition 8000 DC power supply
The X-Pedition 8000 DC power supply has a three-terminal wiring block on the front panel, consisting of a positive (+) terminal, negative (-) terminal and a safety ground. The DC supply is designed to be powered by a 48-Volt DC source. Figure 7 shows the front view of an X-Pedition 8600 DC Power Supply.
To be installed in a restricted ! access area in accordance
with the NEC or authority having jurisdiction.
See manual for installation
PWR instructions.
SSR-PS-16-DC
SN
48/60V 27A MAX
Figure 7. Front view of an X-Pedition 8600 DC power supply
The X-Pedition 8600 DC power supply has a five-terminal wiring block on the front panel, consisting of two positive (+) terminals, two negative (-) terminals and a safety ground. The DC supply is designed to be powered by a 48-Volt DC source.
18 | Enterasys X-Pedition 8000/8600 Getting Started Guide |
