Enterasys Networks 8000/8600 manual Configuration Commands in the Scratchpad on

Problem	Solution
The control module is not active.	Check the power cable and the circuit to which
	the power supply is connected.
	If the power supply is working, make sure the
	control module is inserted all the way into its
	slot in the chassis and the captive screws are
	screwed in. The control module must be in slot 0
	or 1—not in a line card slot.
No line cards are active.	Check the power cable and the circuit to which
	the power supply is connected.
A specific line card is inactive.	Make sure the line card is inserted all the way
	into the chassis and the captive screws are
	screwed in.
The chassis LEDs indicate activity but you	Make sure you have properly connected the
cannot tell what the X-Pedition is doing.	primary control module to a management
	console and the console is powered on.
An older software version continues to boot	Use the procedure in Loading System Image
instead of the newer version on a PCMCIA	Software on page 96 to configure the X-Pedition
card or TFTP server.	to boot using newer software.
You are unable to access the configuration	Enter the enable command to access the Enable
commands in the CLI.	mode, then enter the configure command to
	access the Configuration mode.
Configuration changes do not seem to be	Use the procedure in Activating the
taking effect.	Configuration Commands in the Scratchpad on
	page 98 to activate the changes.
Configuration changes are not reinstated	Use the procedure in Saving the Active
after a reboot.	Configuration to the Startup Configuration File
	on page 99 to save the configuration changes to
	the Startup configuration file.

102 Enterasys X-Pedition 8000/8600 Getting Started Guide