Enterasys Networks 8000/8600 manual Handling the Module, Tools, Hot Swap, Remove the module

Installing the Hardware

Handling the Module

Caution: Line cards are easily damaged by electrostatic discharge.

To prevent electrostatic damage, observe the following guidelines:

•Do not remove the module from its packaging until you are ready to install it.

•Do not touch any of the module’s pins, connectors or components.

•Hold the module only by its edges or front panel.

•Wear an anti-static wristband connected to a suitable earth ground whenever handling the module.

•Store or transport this module only in appropriate anti-static packaging.

Tools

Typical installations require the following tools:

Anti-static wristband Phillips screwdriver Flathead screwdriver

Hot Swap

You may install most modules into a live system without powering off the device. However, do not remove an active module from a live system except under the following conditions:

•Press the Hot Swap button on the front panel. The Online LED will turn off and the Offline LED will turn on.

OR...

•Enter the following from the CLI and click enter: Enable -> System -> Hotswap -> Out -> Slot -> #. The Online LED will turn off and the Offline LED will turn on.

•Remove the module.

For more information on hot swapping, see Hot Swapping Line Cards and Control Modules in the Enterasys X-Pedition User Reference Manual.

Warning: Do not insert tools or body parts in the chassis while it is powered on. Doing so may cause electrical shock or equipment damage.

Enterasys X-Pedition 8000/8600 Getting Started Guide 77