Enterasys Networks 8000/8600 manual Ports

Hardware Overview

APHY-92V		• 1 E-1 interface (UTP); see APHY-82Von page 81 for attaching
	APHY-92V	cables
PHY		Note: The APHY-92V is not an E1 interface. It merely allows you
		to connect to an E1 CSU—the E1 CSU will allow you to
		connect to an E1 circuit.

•ITU-T G.703 for a symmetrical pair

•120 ohm symmetrical pair

•Maximum of 655 ft (200 m) of cable

•0 through 6 dB loss at 200 m

APHY-21	•	1 OC-3c MMF interface (SC-style); see APHY-21 and APHY-
	APHY-21	29IR on page 81 for attaching cables
PHY	•	EIA/TIA 492-AAAA

• 62.5/125 µm

•Maximum cable length cannot exceed 2 kilometers (maximum will allow up to three cables—two splices). Additional cables/splices will reduce the maximum cable length.

•0 to 9 dB loss at 1300 nm

APHY-29IR	•	1 OC-3c SMF-IR interface (SC-style); see APHY-21 and APHY-
	APHY-29IR	29IR on page 81 for attaching cables
PHY	•	EIA/TIA 492-CAAA

• 9/125 µm

•Maximum cable length cannot exceed 15 kilometers (maximum will allow up to three cables—two splices). Additional cables/splices will reduce the maximum cable length.

•0 to 15 dB loss at 1300 nm

APHY-22	•	1 OC-3c interface (UTP); see APHY-22on page 82 for attaching
	APHY-22	cables
PHY	•	EIA/TIA 568B

• 295 ft (90 m) of Category 5 building cable

•33 ft (10 m) of Category 5 patch cords

•1 punchdown block (Category 5)

Ports

Depending on the APHY used, 1 or 2.

Enterasys X-Pedition 8000/8600 Getting Started Guide 23