Enterasys Networks 8000/8600 LEDs SSR-GLX39-04 and SSR-GSX31-04 LED Indicators, Condition Status

Hardware Overview

LEDs

Table 6. SSR-GLX39-04 and SSR-GSX31-04 LED Indicators

LED	Condition	Status
Offline	On	The line card is offline (powered off) and ready to hot swap.
		This LED also lights briefly whey you reboot or reset the
		X-Pedition but turns off as soon as the control module discovers
		the SSR-GLX39-04 or SSR-GSX31-04.
Online	On	The SSR-GLX39-04 or SSR-GSX31-04 is ready to receive,
		process, and send packets (if configured).
Per-Port Link	Green	Indicates that the port hardware detected the cable plugged into
		the port and a good link is established.
	Red	The port received an error during operation.
	(intermittent)
	Red	The port hardware detected a cable plugged into the port, but a
		bad link was established.
	Off	No link from the port exists.
Per-port Rx	Green	The port’s transceiver is receiving packets.
	Amber	The port’s transceiver is receiving flow-control packets.
Per-port Tx	Green	The port’s transceiver is transmitting packets.
	Amber	The port’s transceiver is transmitting flow-control packets.
Per-port AN	Green	The line card auto-negotiated the operating mode of the link
		between full-duplex and half-duplex.
	Amber	Auto-Negotiation is in progress.
	(intermittent)
	Amber	Indicates a problem with Auto-Negotiation configuration.
	Red	An Auto-Negotiation failure occurred.This fault may occur if the
		link partner does not support full-duplex operation.
	Off	Auto-Negotiation is disabled or the link is down.

32 Enterasys X-Pedition 8000/8600 Getting Started Guide