Enterasys Networks 8000/8600 manual Appendix a Troubleshooting, Problem Solution

Appendix A

Troubleshooting

If you experience difficulty with the basic hardware or software setup procedures in this guide, check the following table. If you find a description of the difficulty you are experiencing, try the recommended resolution.

If the resolution does not remove the difficulty or it is not listed in this appendix, see Appendix C for information about contacting Enterasys Networks for technical support.

Problem	Solution
The Enterasys X-Pedition exhibits no	Make sure the power supply is installed and
activity (no LEDs are on, the fan module is	plugged into a power source and the power
not operating, and so on).	source is active. Also check to see whether the
	switch on the power supply is in the ON
	position.
The power supply is installed but is not	Check the power cable and the circuit to which
operating.	the power supply is connected.
The fan module is not active.	Check the power cable and the circuit to which
	the power supply is connected.
	If the green status LED on the power supply
	indicates that it is active, immediately power
	down the chassis, unplug the power supply, and
	contact Enterasys Networks for technical
	support. The fan module may be improperly
	connected or damaged.

Enterasys X-Pedition 8000/8600 Getting Started Guide 101